Nintendo Entertainment System User manual

Super Nintendo –InGameReset Functionalities
Force region 50Hz (PAL) (LED green)
L + R + Select + Y
Force region 60Hz (NTSC) (LED red)
L + R + Select + A
Force region of cartridge (LED yellow)
L + R + Select + B
Change to SCICs forced region (e.g. for pairmode with sd2snes)
L + R + Select + D-Pad left OR right

Simple reset of console
L + R + Select + Start
Double reset (change to main menu of sd2snes)
L + R + Select + X
Toggle region timeout on and off
-Regionen timeout:force cartridge region after consoles start-up, reset and double reset for approximately 9s
afterwards change to forced region
-LED confirms with off -> red -> yellow -> green -> off -> "LED normal" on switching on
-LED confirms with off -> green -> yellow -> red -> off -> "LED normal" on switching off
L + R + Select + D-Pad up
-Toggle region patching on and off
-Region patching, also $213f-D4-Patch: suppresses cartridge error "This Gamepack is not designed for […]"
after reading register $213f by overriding bit 4 (region bit)
-LED confirms with off -> green -> off -> green -> off -> "LED normal" on switching on
-LED confirms with off -> red -> off -> red -> off -> "LED normal" on switching off
L + R + Select + D-Pad down

Toggle lock (type 1) on and off
-Lock (type 1): locks all combinations except this one. Lock can be removed using the same combination
again. This lock state is stored during powering off and on the SNES.
-LED confirms with fast flashing red on switching lock on
-LED confirms with fast flashing green on switching the lock off
D-Pad left + D-Pad up + L + R + X + A
Set lock (type 2)
-Lock (type 2): locks all combinations. The lock can only be unset using a reset or switching off and on the
console. Reset using the sd2snes’ IGRs is not supported; one has to use the reset button.
-LED confirms with fast flashing red
D-Pad down + D-Pad left + L + R + A+ B
(These locking combinations are only available if you have flashed the right *.hex-file to the PIC-microcontroller)