User Instructions
The Economy Shower Chair is intended to be used
in a shower to provide a stable, seated support,
where a user is unable to stand for long periods (i.e.
during showering).It may be used with or without
the back rest.
Specification
Seat height Adjustable from 35 - 53cm
Seat Size: 49.5 x 29.5cm
Footprint 45 x 48.5cm
Max User Weight: 102 Kg (16st)
Contents Quantity
Bottom Legs 2
Chamfered bolts 4
Cupped Washer 5
Seat 1
Round head bolts 5
Back support Tube 2
Back 1
User Instructions 1
Assembly and Height Adjustment
Tools required: Philips Screwdriver
4. Put seat upside down on floor/flat surface
5. Align seat legs on the seat, so that the legs nest
together in line with the seat moulding.
6. In the centre of the seat, loosely install a round
head bolt through the cupped washer, top leg,
bottom leg and tighten to the seat as shown in
Fig 1.
7. Install the four chamfered bolts through the legs
into the seat moulding. Tighten all 5 bolts.
Maximum User Weight:
102Kg (16st)
Economy Shower Chair
L97792
Assembly and Height Adjustment - cont.
1. Align the back support tubes with the back
moulding.
2. Install the four round head bolts through the
cupped washers, back support tubes and into
the back moulding and tighten. (Fig 2).
3. Fit the back rest to the shower chair by
depressing the snap buttons and inserting the
back rest tubes into the location tubes in the
underside of the seat until it snaps into the
appropriate adjustment hole (Fig 3). Note: Two
back rest positions are possible; choose the
one which is most comfortable. Ensure the
same snap button is used so that the back rest
is not angled to the seat.
Please ensure these instructions are fully
read and understood before installation/
use. Retain these instructions in a safe
place for future reference.
Fig 1 - Assembly diagram
Page 1 of 2
