Numatic TWINTEC CABLE ET4045 Installation and operation manual

2.
4.
1.
3.
5.
Clean out the debris lter basket
located under the seperator hood.
Empty the recovery tank and rinse
thoroughly with clean water.
Clean suction pod lter located in the
seperator hood behind the black ap.
Ensure the seperator is clean and un-
damaged. Replace seal if necessary.
IMPORTANT: Clean underside of
squegee from dirt and debris.
NET4045DMVNo1
REPORT ALL DAMAGES AND TECHNICAL ISSUES TO THE SUPERVISOR
AFTER EVERY USE, ENSURE
THAT YOU COMPLETE THE
FOLLOWING 6 STEPS
NUMATIC TWINTEC CABLE
ET4045
DAILY MAINTENANCE CHART
6.
Store machine with seperator lifted
from the tank to avoid condensation.

AFTER EVERY WEEK, ENSURE
THAT YOU COMPLETE THE
FOLLOWING 4 STEPS
1.
3.
2.
4.
Check all all hoses for damage, holes and
obstructions. Clean and replace as necessary.
Thoroughly clean top seperator hood and
seal.
IMPORTANT: Remove squegee and check for
wear and damage. Clean thoroughly. Remove brushes/pad drives and
check for wear and damage.
NET4045WMVNo1
REPORT ALL DAMAGES AND TECHNICAL ISSUES TO THE SUPERVISOR
NUMATIC TWINTEC CABLE
ET4045
WEEKLY MAINTENANCE CHART
2
3
4
1