NXP Semiconductors FRDM-STBC-AGM04 User manual

Quick Reference
FRDM-STBC-AGM04
Sensor Toolbox Development Platform for
MMA8652FC 3-axis digital accelerometer,
FXAS21002C 3-axis digital angular rate gyroscope, and
MAG3110 3-axis digital magnetometer
SENSOR TOOLBOX SHIELD DEVELOPMENT BOARD

Quick Reference
GET TO KNOW THE FRDM-STBC-AGM04
Figure 1: FRDM-STBC-AGM04
6 – I2C_SCL1
5 – I2C_SDA1
7 – GND
IN1_8652 – 3
IN1_21002 – 5
IN1_3110 – 6
IN2_8652 – 1
IN2_21002 – 3
I2C_SCL0 – 10
I2C_SDA0 – 9
6 – GND
4 – VDD
2 – VDD
Test points (14 places)
Through hole pins (14 places)
MAG3110 3-axis, digital magnetometer
10 DFN (2 mm x 2 mm x 0.85 mm)
FXAS21002C 3-axis digital angular rate gyroscope
24 QFN (4 mm x 4 mm x 1 mm)
MMA8652FC 3-axis, 12-bit,
digital accelerometer
10-pin DFN (2 mm x 2 mm x 1 mm)

www.nxp.com
NXP and the NXP logo are trademarks of NXP B.V. All other product or service names are the property of their
respective owners. © 2016 NXP B.V.
Document Number: FRDM-STBC-AGM04 REV 0
Agile Number: 920-29415 REV A
www.nxp.com
HOW TO GET STARTED
1. Connect the FRDM-STBC-AGM04
development board to an NXP
Freedom development board, such
as the FRDM-K64F (or any Arduino R3
compatible board). Refer to the NXP
Freedom development board
Quick Start Guide for driver information.
The latest drivers for the FRDM boards
can be found at:
www.nxp.com/openSDA
2. Plug one end of a USB cable into the
SDA port on the assembly. Plug the
other end of the cable into the USB
port on the computer.
3. Download and install the latest
Sensor Toolbox software at:
www.nxp.com/sensortoolbox Figure 2: Connect board to computer