Nyne Nyne TT Instruction manual

Nyne TT
Quick User Guide
EN
Bluetooth Speaker Series
EN
All registered and unregistered trademarks are
property of their respective owners.
Nyne Multimedia Inc.
All rights reserved.
QUG-TT-11-3-2013-V.1.0
nyne.com
Extend the stand and place the speaker
on a hard at surface.
Connect power.
Tip: The speaker is only compatible with the original
power adapter included in the package.
Slide the power switch to the ON position.
+The built-in battery starts charging
automatically.
Tip: The speaker is fully charged
when the indicator turns
from white to green. You can use
either the AC power or built-in
battery as power supply.
EN EN
EN
Press to power on.
+The Bluetooth indicator ashes blue, indicating
that the speaker is in pairing mode.
Tips: If there is no power to the speaker after you
press the power button, check that:
(1) the speaker is connected to AC power or
the battery is fully charged;
(2) you have slided the power switch to the
ON position.
If the problem remains, slide the power switch
to the OFF and then ON position again.
You can press again or slide the power
switch to the OFF position to power off.
To save power, the speaker turns off
automatically after 30 minutes of inactivity.
EN

Nyne TT
(1) Make sure that the speaker is in pairing mode.
(2) Enable Bluetooth on your device to be paired with the speaker.
(3) Select ‘Nyne TT’ from the available devices (enter the password
‘0000’ if necessary) to start pairing and connection with the
speaker.
(4) After successful connection, the Bluetooth indicator turns solid
blue and the speaker beeps.
Tips: This speaker supports automatic connection with a
previously paired device after power-off and power-on
again.
You can press and hold for more than 2 seconds to enter
manual pairing mode. In this way, you can pair the speaker
with a new Bluetooth device.
You can press and hold both +and - for more than 10
seconds to clear all paired Bluetooth devices.
This speaker is Siri-compatible.
EN
(1) Connect an auxiliary audio device to the speaker through
the supplied 3.5mm audio cable.
(2) Play and control music on the audio device, and use +/-
on the speaker to adjust volume if necessary.
Tip: When the 3.5mm audio cable is plugged in, the
speaker switches to AUX IN mode automatically.
When it is unplugged, the speaker switches back to
Bluetooth mode and connects with the previously
paired device automatically. If no device is
available, the speaker enters pairing mode.
EN
Play music on your device paired and connected with
the speaker.
During music play:
• Press +/- to adjust volume.
• Press to skip to the previous or next song.
When you make a call or there is an incoming call, you
can use the speaker as a speaker phone.
• When there is an incoming call, you can press to
receive the call.
• During a call, you can press to end the call.
• When using Siri on your Apple devices, you can press
twice to enable Siri support on the speaker.
Tips: Music play is paused during a call and resumed
automatically when the call ends.
You can press and hold to disconnect the current
Bluetooth connection.
EN
Charge your mobile device through the 5V
USB charging socket.
EN

Nyne TT
Safety Guide
EN
Bluetooth Speaker Series
EN
All registered and unregistered trademarks are property
of their respective owners.
Nyne Multimedia Inc.
All rights reserved.
SG-TT-11-3-2013-V. 1.0
nyne.com
Important
Safety
with arrowhead
symbol within an
equilateral triangle
is intended to alert
the user to the presence of un-
isolated, dangerous voltage within
the inside of the device that may be
risk of electric shock to persons.
Warning: To reduce the risk of electric
shock, do not remove cover (or back)
as there are no user-serviceable parts
personnel.
The exclamation
point within an
equilateral triangle
is intended to alert
the user to the presence of important
operating and servicing instructions
in the literature accompanying the
device.
or electric shock, do not expose this
apparatus to rain or moisture. The
apparatus shall not be exposed to
dripping or splashing and that objects
not be placed on apparatus.
WARNING: Where the mains plug/
appliance coupler is used as the
disconnect device, the disconnect
device shall remain readily operable.
WARNING: The battery (battery or
batteries or battery pack) shall not be
exposed to excessive heat such as
Read these instructions before
operation.
Keep these instructions for future
reference.
Follow all instructions for installation,
use and maintenance of the device.
To avoid tilt or drop, place the device
To clean the device, disconnect
dry cloth.
To ensure compatibility, only use
accessories recommended by the
manufacturer.
When the device is suddenly moved
from cold to warm surroundings,
condensation may form in the
housing of the device. Before use,
leave the device in the warm
environment until the moisture
evaporates.
Keep the device away from heat
sources, such as a radiator, heater,
direct sunlight.
lighted candles, should be placed on
the apparatus.
Never block any ventilation openings.
Install in accordance with the
manufacture’s instructions.
•Do not expose the device to
sand or dust, or cover it with
items, such as newspapers, table
cloths, or curtains.
•Do not operate the device in
an enclosed cabinet. Leave
device for adequate ventilation.
Do not attempt to repair or service
the device yourself. Opening or
removing the cabinet may expose
you to electric shock, and other
hazards. If repair is required, contact
your dealer and refer all servicing to
Do not use the device if any
abnormality occurs. If any smoke or
odor becomes apparent, contact
your dealer immediately. Do not try to
repair the device yourself.
Avoid using dropped or damaged
appliances. If the device is dropped
and the housing is damaged, the
internal componentsmay not function
normally. Stopuse and contact your
dealer for repair. Continueduse of
shock.
To reduce the risk of electric shock,
do not touch any connector with wet
hands.
Never remove the housing of the
device.
Never lubricate any part of the
device.
Never place the device on top of any
other electrical equipment.
This equipment is a Class II or double
insulated electrical appliance. It has
been designed in such a way that it
does not require a safety connection
to electrical earth.
Notice
Modification
the speaker grill) to the device,
without prior authorization from
the manufacturer, may void your
warranty and authority to operate
the device.
FCC compliance statement
This equipment has been tested
and found to comply with the
limits for a Class B digital device,
pursuant to part 15 of the FCC
Rules. These limits are designed
to provide reasonable protection
against harmful interference in a
residential installation. This equipment
generates, uses, and can radiate
radio frequency energy and, if not
installed and used in accordance
with the instruction manual, may
cause harmful interference to radio
communications. However, there is
no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and
on, the user is encouraged to try to
correct the interference by one or
more of the following measures:
•Relocate the receiving antenna.
•Increase the separation
between the equipment and
receiver.
•Connect the equipment into
an outlet on a circuit different
from that to which the receiver is
connected.
EN •Consult the dealer or an
experienced radio/TV technician
for help.
This device complies with Part 15 of
the FCC Rules. Operation is subject
to the following two conditions: (1)
This device may not cause harmful
interference, and (2) This device must
accept any interference received,
including interference that may
cause undesired operation.
This Class B digital apparatus complies
with Canadian ICES-003.
Cet appareil numérique de la classe
B est conforme à la norme NMB-003
du Canada.
This device complies with FCC RF
radiation exposure limits set forth for
an uncontrolled environment.
This equipment should be installed
and operated with a minimum
distance of 20cm between the
radiator and your body.
This device and its antenna(s) must
not be co-located or conjunction
with any other antenna or transmitter.
CE statement
This product complies with the radio
interference requirements of the
European Community.
Recycling
Packaging
Observe the local regulations for
how to dispose of the packaging
materials.
WEEE NOTICE
The Directive on Waste Electrical and
Electronic Equipment (WEEE), which
entered into force as European law
on 13th February 2003, resulted in a
major change in the treatment of
electrical equipment at end - of - life.
The purpose of this Directive is, as a
and in addition, to promote the
reuse, recycling and other forms
of recovery of such wastes so as to
reduce disposal.
The WEEE logo on the product or
on its box indicating collection for
electrical and electronic equipment
consists of the crossed -out wheeled
bin, as shown below.
This product must not be disposed of
or dumped with your other household
waste. You are liable to dispose
of all your electronic or electrical
waste equipment by relocating over
for recycling of such hazardous
waste. Isolated collection and
proper recovery of your electronic
and electrical waste equipment at
the time of disposal will allow us to
help conserving natural resources.
Moreover, proper recycling of the
electronic and electrical waste
equipment will ensure safety of
human health and environment. For
more information about electronic
and electrical waste equipment
disposal, recovery, and collection
points, please contact your local
city center, household waste
disposal service, shop from where
you purchased the equipment, or
manufacturer of the equipment.
ROHS COMPLIANCE
This product is in compliance with
Directive 2011/65/EU of the European
Parliament and of the Council of 8
June 2011 on the restriction of the use
of certain hazardous substances in
electrical and electronic equipment.
FOR PRODUCTS THAT INCLUDE BATTERIES
EU Batteries Directive 2006/66/EC
A new battery directive 2006/66/
EC on Battery and Accumulator
replacing directive entered into
force on the 26th September 2008.
The directive applies to all types
of batteries and accumulators
(AA, AAA, button cells, lead acid,
rechargeable packs) including those
incorporated into appliances except
for military, medical and power tool
applications.
The directive sets out rules for
collection, treatment, recycling and
disposal of batteries, and aims to
prohibit certain hazardous substances
and to improve environmental
performance of batteries and all
operators in the supply chain.
Instructions for Users on Removal, Recycling and Disposal
of Used Batteries
To remove the batteries from your
equipment or remote control, reverse
the procedure described in the
owner’s manual for inserting batteries.
For products with a built-in battery
that lasts for the lifetime of the
product, removal may not be
possible for the user. In this case,
recycling or recovery centers handle
the dismantling of the product and
the removal of the battery. If, for
any reason, it becomes necessary
to replace such a battery, this
procedure must be performed
by authorized service centers. In
the European Union and other
locations, it is illegal to dispose of
any battery with household trash.
All batteries must be disposed
of in an environmentally sound
manner. Contact your local waste-
regarding the environmentally sound
collection, recycling and disposal of
used batteries.
WARNING: Danger of explosion if
battery is incorrectly replaced. To
disassemble, crush, puncture,
short external contacts, expose to
temperature above 60°C (140°F), or
The symbol indicating ‘separate
collection’ for all batteries and
accumulators shall be the crossedout
wheeled bin shown below:
In case of batteries, accumulators
and button cells containing more
than 0.0005 % mercury, more than
0.002 % cadmium or more than
0.004 % lead, shall be marked
with the chemical symbol for the
metal concerned: Hg, Cd or Pb
respectively. Please Refer to the
below symbol:
Copyright
The Bluetooth word mark and logos
are owned by the Bluetooth SIG, Inc.
and any use of such marks by Nyne
Multimedia Inc. is under license.
Specifications
Output power 2 x 10W
Speaker drivers 2 x 2.8”
S/N >50dB
THD+N <10%
Dimension (LxWxH) 258(W) x 148(H) x 52(D) mm
Weight 0.89 kg
Audio input 1 x 3.5 mm socket
1 x wireless input (Bluetooth)
Wireless Bluetooth 4.0
Battery capacitor 7.4V 2200mAh
Play time 6 hours