O3 Waterworks SB-100HD User manual

clean with the
power of nature
USER MANUAL
Model: SB-100HD
ENHANCED OXYGEN SPRAY BOTTLE

CONTENTS
1Safety ............................................................................................... 3
1.1 Symbols from the User Manual ...................................... 3
1.2 Proper Use.............................................................................. 3
1.3 Caution .................................................................................... 3
1.4 Important Instructions.......................................................4
2Technical Data .............................................................................. 5
3Description..................................................................................... 6
3.1 Description............................................................................. 6
3.2 Key Components ................................................................. 6
3.3 Operating Instructions....................................................... 7
4Preventative Maintenance / Cleaning ................................ 9
5Troubleshooting........................................................................... 9
5.1 Indicator Lights on Top of Bottle .................................. 9
6Decommissioning...................................................................... 10
6.1 Storage .................................................................................. 10
6.2 Disposal................................................................................. 10
7Service ............................................................................................ 11
7.1 Service and Warranty ........................................................11
2

Important information can be found here.
NOTICE indicates a situation which, if not avoided, may result
in damage to the appliance.
CAUTION
NOTICE
IMPORTANT!
SAFETY
1.1 SYMBOLS FROM THE USER MANUAL
1.2 PROPER USE
Before initial use, the instructions on operating safety, use and maintenance
must be read carefully and understood. Keep the user manual in the vicinity of
the appliance for later reference.
CAUTION indicates a potentially hazardous situation which, if
not avoided, may result in minor or moderate injury.
The O3waterworks Enhanced Oxygen Spray Bottle is intended for residential
use. It is designed for safe operation when used as directed. The following
general safety precautions provide guidance for safe use. Failure to comply with
the safety precautions or warnings indicated in this manual violates the safety
standards of this equipment. The manufacturer and distributer assume no
liability for the user’s failure to comply with these requirements.
• Read manual before use.
• It may only be used for its intended purpose.
• Product is intended for residential use.
• Do not remove warning labels from unit.
• Fill with clean, potable water only.
• Do not immerse unit in water. Clean exterior of unit with soft cloth.
Do not use harsh or abrasive cleaners.
• Do not add any cleaning chemicals into the water reservoir.
1.3 CAUTION
Do not spray toward eyes. In case of eye exposure rinse aected eye(s)
thoroughly with clean water for 5 to 10 minutes. If irritation persists, seek
medical attention.
• Use only properly ventilated area in conformance
to all local and national regulations.
• If overly strong odor of ozone is detected discontinue use.
• If respiratory irritation is experienced discontinue use immediately.
• Do not expose plastic sprayer to extreme heat or open flame.
• Keep out of the reach of children.
• Do not drop sprayer.
3

1.4 IMPORTANT INSTRUCTIONS
To avoid appliance damage:
Do not drop the bottle.
– Dropping the bottle may cause breakage.
Fill with clean potable water only.
– Filling the bottle with fluids other than clean potable water
may damage electrolytic cell and render the product useless.
Do not overfill the bottle.
– Overfilling may cause leakage at the fill plug.
Do not run water into the charger port.
– Doing so may short the battery/electronics.
NOTICE
SAFETY
(cont’d)
4

SPECIFICATIONS
Materials
Weight
(empty)
Dimensions
(in mm)
Reservoir
Capacity
Water
Temperature
Water
Quality
Ambient
Air
Rechargeable
Battery
Useful
Battery
Life
Model #
Certifications
EPA
Establishment
Number
PC/ABS Impact Resistant Plastic
~ 1.45 lb (0.66 kg)
4.75 in x 5.5 in x 10 in
(120.7 mm x 139.7 mm x 250 mm)
10 oz (295.7 ml)
40°F to 86°F (4°C to 30°C)
Hardness ≤250 ppm CACO3
(May Extend Life of Unit)
Conductivity >50 μS/cm
(Cell damage may result from
use of distilled or deionized water)
40°F to 104°F (4°C to 40°C)
7.4 V Li-Ion
(Charger uses 100 V AC to
240 V AC, 50/60 Hz)
600 Reservoir Fills
or 500 Charges (Typical)
SB-100HD
CE, TUV, RoHS, WEEE
089373-MA-001
TECHNICAL DATA
5

DESCRIPTION
3.1 DESCRIPTION
The O3waterworks Enhanced Oxygen Spray Bottle oers a water-based
alternative to traditional cleaners and sanitizers. It turns potable water into
aqueous ozone, a sanitizer that kills many common pathogens found on
hard, non-porous surfaces and destroys organic odors.
The tiny electrolytic cell is created from a proprietary diamond process
technology and generates ozone on-demand from water itself. Water
exists in the reservoir and the ozone is activated on-demand, creating the
sanitizer. This eliminates the need for many household chemicals and the
constant need to repurchase supplies. Furthermore, it leaves no residue.
1. Indicator LEDs
2. Charging Port
3. Spray Nozzle
4. Diamond Cell
5. Spray Trigger
6. Fill Plug
7. Water Reservoir
8. Battery & Control
Electronics
3.2 KEY COMPONENTS
NOTE: Product may vary from illustrations
6
1
2
6
3
7
8
4
5

After Charging, it is important to securely
push protective flap back in place.
Charge plug location
Water Based Sanitizer
• Proven sanitizer
• Reduces common pathogens
• Destroys odor-causing microorganisms
• Ensures ecacy and compliance with EPA requirements
Dependable, On-Demand Solution
• Ozone (O3) is activated as needed
• Runs on long lasting rechargeable batteries
• Requires only clean, potable water
• User-friendly lights indicate when sanitizer is active
Alternative
• Leaves behind no residues
• Compatible with all surfaces where water may be used
• Eliminates potential errors with mixing or diluting
• Ingredients by weight:
– 99.9998% Water – 0.0002% Ozone – No fragrance added
IMPORTANT: Please read these instructions completely before use.
Use this product to Sanitize hard, non-porous surfaces. Generally regarded
as safe by EPA for direct food contact and food surfaces, 21CFR Part 173
Section 173.368.
• Tables and countertops • Doors and handles
• Kitchen surfaces • Pet accident odors
• Bathroom surfaces • Windows
Charge the Unit
Before using the sprayer for the first time,
charge the batteries. The first charge may
take up to 3 hours. The red light on the
charger indicates that the device is being
charged. The charge is complete when the
light on the charger is green.
NOTE: The spray bottle will not operate
while connected to the battery charger.
Connect the battery charger to a 100-240
V AC 50/60 Hz power source. Connect the
battery charger power cord to the spray
bottle. The system is powered by a 7.4 V
Li-Ion rechargeable battery pack. A 100 to
240 V AC 50/60 Hz charger is included.
User only the charger provided.
3.3 OPERATING INSTRUCTIONS
7

While spraying, blue light indicates
unit is working properly.
Hold 6-8” away from surface.
Sit bottle on counter and check
water level with fill line.
Secure fill plug.
Fill with 10 oz of only water.
Fill the Reservoir
Prepare 10 oz of clean, cold potable water to
fill the bottle. Remove the fill plug and tilt the
bottle at a 45° angle. Fill the reservoir with
10 oz of clean, cold potable water. Replace
the fill plug securely. Return bottle to vertical
position and check fill line. Adjust until water
reaches fill line. Do not overfill. Do not fill with
hot water or any cleaning products.
Prime the Spray Bottle
When new, or after long storage, the ozone
generator in the head of the bottle may
become de-primed. When the ozone cell is
dry, the blue light will not illuminate while
spraying. A primed spray bottle should
spray uninterrupted for at least 30 seconds
with the blue light illuminated.
To prime the spray bottle, continue to
spray with the blue light o until the blue
light turns on. If the blue light does not
illuminate after 2 minutes of spraying, the
bottle may need to be primed using salt.
Additionally, if the bottle starts spraying
with the blue light illuminated and then
stops spraying with the blue and red lights
then flashing twice, your bottle may need
to be primed using salt.
To prime the spray bottle with salt:
1. Fill the spray bottle with water
2. Add 1 tsp of regular table salt
3. Spray the full tank into the sink
4. Fill the spray bottle with fresh tap water
5. Your bottle is now ready to use
Please note: the ozone cell may need to be
re-primed with 1 tsp of salt if unit is unused
for 3 or more months.
If additional support is needed, contact:
[email protected]
CAUTION
FILL WITH CLEAN, COLD POTABLE WATER ONLY.
DO NOT OVERFILL THE BOTTLE. DO NOT RUN
WATER INTO THE CHARGER PORT. WATER
TEMPERATURE 40°F to 86°F (4°C to 30°C)
8
Remove cap.

PREVENTATIVE MAINTENANCE & CLEANING
1. Charge unit nightly to ensure full capacity the next day.
2. Clean bottle with moistened cloth only.
Do not use chemicals or cleaners.
3. When bottle is not in use for an extended period of time, open
the fill cap and empty the reservoir by tilting the bottle and
allow water to drain out the fill port. Leave fill cap unplugged.
Do not spray the bottle with an empty reservoir.
9
Sanitize Hard Non-Porous Surface
Hold the spray bottle 6 to 8 inches from the surface and spray evenly until
wet. For 99.9% eectiveness against common pathogens allow to stand
for 30 seconds. Wipe with a clean cotton or microfiber cloth or allow to
air dry. No rinsing is necessary (leaves no residue). Ozone is generated on
demand. While spraying, the blue indicator will light when the unit is
operating properly.
TROUBLESHOOTING
5.1 INDICATOR LIGHTS ON TOP OF BOTTLE
LIGHTED INDICATORS SYSTEM MESSAGE
SOLID BLUE
ONE RED FLASH
TWO RED FLASHES
THREE RED FLASHES
TWO RED & BLUE FLASHES
ALL OTHER PROBLEMS
System is operating properly
Battery is low
Charger is connected, remover charger
Battery needs recharging
System fault; recharge and try again.
If error persists, follow the Prime the Spray
Bottle section on page 8. If error persists,
contact service department.
Contact service department.

10
DECOMMISSIONING
(
STORAGE / DISPOSAL
)
6.1 STORAGE
Before storing the bottle, spray about 3 oz of water from the
bottle into a cup. Immediately empty out any remaining water
from the reservoir and pour the 3 oz of sprayed water into
the reservoir. Let the bottle stand for 2 minutes. Empty the
reservoir through the fill plug and leave the blue cap unplugged
to allow the reservoir to air dry. Do not spray the bottle with
an empty reservoir.
6.2 DISPOSAL
Disassembly of the appliance must be performed by qualified
specialists according to the manufacturer’s instructions.
– Follow the local safety regulations.
– Dispose of the appliance in accordance with local regulations.
– It is essential that you observe the laws and regulations
for the disposal of environmentally harmful substances.
Obtain detailed information about their disposal – such
substances include plastics and decommissioned battery
packs and Li-Ion battery.
Special regulations apply when dispos-
ing of used electrical appliances:
The customer assumes responsibility for
proper disposal of the delivered product
after the end of its service life at the
customer’s own expense, in accordance
with legal regulations.

7.1 SERVICE & WARRANTY
The manufacturer warrants new equipment to be free of defects
due to poor materials or workmanship for the period of time
listed below (following the date of original installation):
• One year replacement
Exclusions: Certain O3waterworks parts that are expendable
by nature and that need to be replaced frequently may not be
covered. O3waterworks is not liable under these warranties for
repairs or damages due to improper operation, attempted
repairs or installation by unauthorized persons, alterations,
abuse, fire, flood, or acts of nature.
Additionally, this warranty may be voided in the case of:
• Failure to follow instructions for use, care or maintenance
• Removal, alteration or defacing of the serial number
and other labels
• Service by a non-authorized service company
• Mechanical damage
• Use with any other fluids other than clean, potable water
This warranty is conditional upon receiving notice of any
defect subject to this warranty within thirty (30) days of its
original discovery by the Buyer.
For service or warranty questions, contact customer service.
[email protected]
11
SERVICE

Distributed by:
o3waterworks, LLC.
207 Byers Creek Road, Unit D
Mooresville, NC 28117
Manufactured by:
Enozo Technologies
300 Willow Street
North Andover, MA 01845
EPA Est. No.
089373-MA-001
For support, contact:
[email protected]
Model: SB-100HD