Ocean Blue 400201 Setup guide

Above Ground A-Frame Pool
Ladder Conversion Kit
Assembly and Installation Manual
Part no. 400201
Tools Needed: Rubber Mallet,
cordless drill with Phillips bit.
Step #1
Parts List
■2 - Return Handrails
■2 - Mounting Blocks Rails
■2 - Mounting Blocks
■1 - Hardware Safety Pack:
16 - ¼-10 x 3/4” Philips
self-tapping screws
#1: Remove the Swing-up Ladder
assembly by exing the oval
openings outward from the tabs on
the Platform.
#2: Remove the
two ¼-20 x 3 1/2”
bolts and ¼-20
hex nuts from the
pool ledge. Then
remove A-Frame
Ladder from pool
and lay it on its side.
#3: Using a cordless drill, remove
the four #10 x 3/4” self-tapping
screws that connect the Handrails
together
#4: Slide the remaining ladder
assembly out of the two holes
nearest the tabs of the platform and
set aside.
#1: With the ladder still on its
side, slide the Return Handrails up
through the bottom of the Platform.
Step #2
#2: Using two #10 x 3/4” self-
tapping screws, connect the Hand-
rail to the Return Handrail by using
one screw on the outside and one
screw on the inside. Repeat for the
remaining handrail.

Step #2 continued
#3: Stand up the assembly and
using a rubber mallet tap the
Platform down until seated on the
lugs on the Side Rails. IT MAY
REQUIRE SEVERAL HARD
BLOWS WITH A RUBBER MALLET
TO SEAT THE PLATFORM ALL
THE WAY DOWN ONTO LUGS.
Step #3
#1: Using the rubber mallet, tap
the Mounting Blocks onto the
Mounting Block Rails.
#2: Lying the ladder assembly on
its side, slide the Mounting Block
assemblies up into the open end
of the Return Handrails as shown.
Ladder is now ready to attach to
your pool deck.
Step #4
Attaching In-Pool Ladder to Your Pool Deck
CHOOSE A LOCATION THAT
IS LEVEL AND IN FULL
VIEW. POOL MUST HAVE
COMPETENT ADULT
SUPERVISION AT ALL
TIMES WHEN IN USE.
#1: Carefully lift the ladder into the
pool. Allow ladder to ll with water
so it settles on the bottom of the
pool. Small holes in the side rails
will let the water in. This may take a
few minutes. Make sure the bottom
tread of the ladder sits rmly on the
bottom of the pool.
OCEAN BLUE WATER
PRODUCTS WARRANTY
Ocean Blue Water Products warrants
their swimming pool ladders to be free
from defects in workmanship for one
year from date of purchase.
DO NOT RETURN DEFECTIVE
PART TO DEALER
The defective part should be
returned, postpaid, to:
Ocean Blue Water Products
7447A S Central Ave
Bedford Park IL 60638
Enclose proof of purchase (receipts,
etc.) showing date purchased, your
name, address, and daytime phone
number. You will be notied of cost to
replace part. This warranty gives you
specic legal rights, and you may also
have other rights which may vary from
state to state.
#2: Position the ladder over the
pool deck with the Mounting Blocks
sitting at. Attach the Mounting
Blocks to the pool deck using four
#10 x 3/4” self-tapping screws in
each mounting block.
#3: Making sure the Platform is
level, attach both mounting block
assemblies to the ladder using four
#10 x 3/4” self-tapping screws in
each assembly.