MANUAL OF
ASSEMBLY AND USE:
Laptable
CLEANING AND MAINTENANCE:
Wood:
Normal cleaning: remove the dust with dry cloth or soft
cloth slightly moistened with water.
Deep cleaning: use a soft sponge slightly moistened with
water and mild detergent. Remove the soap and dry.
Do not make use of oils, waxes and chemicals or abrasives.
Steel Chrome:
Remove the dust with dry flannel or soft cloth, weekly as
the accumulation of dust stimulates the appearance of rust.
Do not use sponges or harsh objects, chemicals with
solvents and alcohol.
Chromed metal is more sensitive to climatic variations. In
areas with sea air the pieces should ideally be set in
air-conditioned locations. Never expose in outdoor
areas such as open balconies.
CARE:
Do not use objects weighing more than 4,5 kg on main top.
Do not place objects on the side table weighing more than 3.5 kg.
Do not place objects in the mouse holder weighing more than 1kg.
Do not turn the table arm too hard or too fast (danger of table
toppling).
Do not join the main and auxiliary arms (danger of knocking down
the table).
Do not extend the main arm to the opposite side of the larger foot
(danger of the table toppling).
Optional:
The mouse holder can be removed without structural damage to
the table.
The holder to cellphone/pencils/and other tools can also be
removed without causing structural damage to the table.
For more information visit our website: useoctoo.com
4
Position the large
storage and secure
it with the M4X10
screws
Attach the main tube
to the wheel base and
rotate it firmly to
secure it.
1
Attach and
rotate the
P-shaped
steel part to
the auxiliary
arm to
secure it.
Pass two flexible
rings through the
tube, and then
attach the auxiliary
arm with
the P-shaped steel
part to the main
tube. It needs to be
aligned with the
smaller foot
of the base.
Attach the main top
arm to the forearm and
secure the allen screw
as shown. This screw
allows the adjustment
of tension in the
rotation of the arm.
To adjust the height of
the table move the
flexible safety rings. If
it is necessary, use the
Allen key "J" to loosen
the screws on the
metal safety ring.
To use the table on the other side,
rotate the main top 180 degrees.
Using the allen key "P", adjust the
3 screws according to the picture
to adjust the tension of the top.
Attach the mouse top
to the hole, right or left
side of the main top,
and turn the key until it
is secure.
Fit the holder to cellphone, pencils
and other tools to the P-shaped
steel part to finish the assembly.
After this,
pass two
more flexible
rings through
the tube and
position it
above the
auxiliary arm.
Pass the forearm
through the tube in
position as per the
picture and that the
circulated limiter
pass behind the
P-shaped steel part.
32
56
789
10 11 PROHIBITED SITUATIONS
OCTOO, Inc
600 S Federal Highway, Suite 211 - Deerfield Beach - FL 33441
561 774 0669
