odass OD-1720 User manual

WARNING
Handle with care. Product may shatter,
crumble or cause injury if not handled
gently.
Washbasin
instruction
manual
Material : Istone solide surface
Read the instructions carefully before
you start to install.
Comply with building and plumbing
codes.
Tighten the drain carefully to not
damage the sink. It could break or
crumble.
1. Thoroughly clean the surface of the counter to be drilled.
Installation
of the washbasin
OD-1720

Installation
of the washbasin
2. Trace the dimensions of the holes to be drilled in the counter.
Measure the space required for the installation of the drain and
faucets.
3. Cut the opening using a jigsaw. Use a soft cloth between the
surface of the counter and the saw to not damage or scratch the
counter.
Make sure you have the necessary space under the counter for the
drain and the piping.
4. Apply plumber's putty along the inside edge under the washbasin.
Place the washbasin in the desired location. Press firmly to spread
the sealant and immediately wipe off the excess with a damp cloth.

Installation
of the washbasin
5. Let the putty dry for a few hours before connecting the water
supply and drain pipes.
6. Install the faucet and drain following the instructions provided.
Tighten the drain carefully to the washbasin to avoid breaking or
cracking the latter.
MAINTENANCE
Clean only with a damp cloth and
mild soap. Avoid using metallic or
abrasive bristles.
NEVER USE ABRASIVE POWDER
(VIM, AJAX, COMET, ETC.),
PETROLEUM DISTILLANT OR
OTHER STRONG SOLVENTS TO
CLEAN THE SURFACE.
LIMITED WARRANTIES
Odass guarantees the matte
white finish of Istone solid surface
products for life and guarantees
the matte black finish of Istone
solid surface products (niches,
shower column and sinks) for 3
years against all defects in
materials or workmanship under
normal conditions of use and
maintenance from the date of
original purchase of the product
by the owner/user, contractor or
builder.
REPAIR
Repairing small scratches for
white finish only: Sand the area
with 240, 400 and 800 grit
sandpaper.
Start sanding with the sandpaper
that has the coarsest grit followed
by the finest. Then, continue by
polishing with a car wax
(NuFinish, Meguiar) or with a
polishing paste (compound).
CAUTION
Do not sand the black finish.
Contact the manufacturer Odass
for all your repair advice or
contact a professional to repair
the black finish.