OEC COMPACT 7600 Manual

COMPACT 7600
Periodic Maintenance Procedure
00-878852-01
Used and Refurbished C-Arms are Available from www.SharpMedical.com - Call us at 800-969-9800
An Independent C-Arm Service Provider. This PDF provided for research / historical purposes only.

ii COMPACT 7600 Periodic Maintenance, 00-878852-01
July 1996
OEC Medical Systems, Inc.
384 Wright Brothers Drive
Salt Lake City, Utah 84116
This manual may not be reproduced, in whole or in part,
without the written permission of OEC Medical Systems, Inc.
This procedure does not contain any steps which can be performed by the system
operator. The steps contained in this procedure should not be attempted by anyone who is
not specifically trained or authorized by OEC Medical Systems, Inc. to work on the COMPACT
7600 System.
The contents of this procedure are believed accurate at the time of publication. However, changes in
design and additional features may be incorporated in the hardware and software which are not
reflected in this version of the procedure. Contact OEC Medical Systems, Inc. for clarification, if
discrepancies arise.
Used and Refurbished C-Arms are Available from www.SharpMedical.com - Call us at 800-969-9800
An Independent C-Arm Service Provider. This PDF provided for research / historical purposes only.

COMPACT 7600 Periodic Maintenance, 00-878852-01 iii
Revision History
Rev Dash Date Change Description
Rev 1 -01 July 1996 Initial Engineering Release
Rev 2 -01 Aug 1996 Added fast stop button operational check
Rev A -01 Aug 1996 Manufacturing Release
Used and Refurbished C-Arms are Available from www.SharpMedical.com - Call us at 800-969-9800
An Independent C-Arm Service Provider. This PDF provided for research / historical purposes only.

iv COMPACT 7600 Periodic Maintenance, 00-878852-01
Used and Refurbished C-Arms are Available from www.SharpMedical.com - Call us at 800-969-9800
An Independent C-Arm Service Provider. This PDF provided for research / historical purposes only.

COMPACT 7600 Periodic Maintenance, 00-878852-01 v
Table of Contents
1. General Instructions................................................................................................................................................1
1.1 Tools and Test Equipment.......................................................................................................................................1
1.2 Necessary Test Equipment.......................................................................................................................................1
1.3 COMPACT 7600 Periodic Maintenance Form........................................................................................................1
2. General Safety..........................................................................................................................................................1
3. Begin PM Form........................................................................................................................................................2
4. Functional Checks....................................................................................................................................................2
4.1 Mechanical Checks..................................................................................................................................................2
4.2 Inspect Drag Cable...................................................................................................................................................2
4.3 Inspect Signal Cables...............................................................................................................................................2
4.4 Inspect/Adjust System Power Supply Voltages .......................................................................................................3
4.5 Measure Line Voltage Regulation............................................................................................................................3
4.6 Perform System Functional Test..............................................................................................................................4
5. Generator Accuracy Verification/Calibration ......................................................................................................6
5.1 Verify X-Ray Calibration.........................................................................................................................................6
5.2 Perform X-Ray Calibration......................................................................................................................................6
6. Radiographic / Fluoro Verification/Alignment .....................................................................................................7
6.1 Verify/Adjust Beam Alignment ...............................................................................................................................7
6.2 Verify/Adjust Fluoroscopic Camera Alignment.......................................................................................................7
6.3 Perform Entrance Exposure Calibration Test...........................................................................................................7
7. Cleanup.....................................................................................................................................................................7
8. Complete PM Form .................................................................................................................................................7
Used and Refurbished C-Arms are Available from www.SharpMedical.com - Call us at 800-969-9800
An Independent C-Arm Service Provider. This PDF provided for research / historical purposes only.