3 4
Materials and Surface Finish
Part Materials Surface finish
Tabletop Surfacing, coaming Melamine board ー
Core material MDF ー
Legs (end leg, middle leg) Legs frame, corbel Steel Baking finish
Modesty panel Main body Steel Baking finish
Wiring duct Main body Steel Baking finish
Leveler Main body Steel Plated
∗Please understand that product specifications might change without prior notification due to improvements made to the
product.
●If you spill tea, coffee, detergent, medicine,
or some other liquid on the product, wipe off
immediately.
●This instruction manual is very important, so
store it in an easily accessible location.
●Regular maintenance is recommended for
long product life.
Make requests to us immediately when a
repair or inspection is needed (fees required
after expiration of warranty).
●Do not use sharp
objects such as a knife
on the tabletop as it
may cause scratches
or damages to the
surface.
●If the product gets wet with water, wipe off
with dry and soft cloth.
Operation Guide
Please follow the instructions below. Failure to do so may cause serious damage to the
product and Okamura will have no responsibility for any damages.
Operating Precautions and Maintenance
Instructions to Extend the Life of Product
For daily care
Wooden part
●Wipe gently along the grain with a soft, clean,
dry cloth.
●If the product becomes noticeably dirty,
remove the dirt using a soft cloth dampened
with water, then use a dry cloth to absorb
water residue.
●For a more thorough cleaning we recommend
using a mild cleaner (thin neutral detergent).
〈Caution〉
●Do not use the following as they may damage
the coating.
◎
Thinner, benzene, alcohol , lacquer, oil,
vinegar, boiling water, polisher, etc.
●Frequent wiping with a damp cloth may cause
cracking of the coating. It is recommended
to use a dry soft cloth or our wiping cloths for
daily care.
Resin part
●Wipe off with a soft cloth dampened with
water.
●When it gets dirty, moisten the cloth with thin
neutral detergent and squeeze it hard to
wipe.
Wipe clean with a damp cloth. Be sure to
wipe detergent completely and wipe again
with a dry cloth to dry it.
Steel part
●Wipe off with a dry soft clean cloth.
●If moisture is collected or substances such
as fingerprints or sebum are adhered,
wipe it off immediately. Leaving moisture,
liquid, fingerprints, or sebum on the surface
accelerates oxidation of the steel part and
deteriorates gloss and texture.
■Leg adjustment
Use the leveler for the legs to keep the table
horizontal to the floor surface if it wobbles
due to uneven floor surfaces.
When using the leveler, ensure that more
than two people provide rigid support
using extreme caution.
Caution Leveler
LowerHigher
20mm
Legs
■Optional accessories
Under surface
power unit
2 Power 1 Dual USB charger MMD3BA Y708 (Black), Y707 (White)
3 Power MMD3BB Y708 (Black), Y707 (White)
Cable guards For 1000H DD287Z –G967 (Black)
For 720H DD285Z –G967 (Black)
■Magnetic vertical wiring duct (optional)
Attach the magnetic vertical wiring duct to the inner-facing side of a leg.
The wiring duct can be attached to the end leg or the middle leg.
Magnetic vertical wiring duct
Single side-standing height table
Standing height table, Standard height table
Magnetic vertical
wiring duct
