Okina USA EIVD36-42VF Quick start guide

EIVD36-42VF_rev04182008
EIVD36-42VF
EIVD36-42VFP
Operational Manual
Weatherproof IR Dome Color Camera
z1/3” Sony Super HAD CCD
z420 TV Lines
z36 IR LED
z3.5mm~8.0mm Vari-Focal Lens
z0.5 Lux @ F1.2 (0 Lux @ IR “on”)
zIR Distance 82~98ft / 25~30m
zWeatherproof IP65 Rating
z300~450mA IR LED "on" / 90~110mA IR LED "off"
z12V DC
1. Unscrew the three mounting screws on the Mounting Ring half way
using the Allen Wrench. Do not unscrew the screws all the way, unless
you have a safe place to store the screws.
2. Lift the Mounting Ring off the Mounting Base, making sure that the
three mounting screws do not fall off. Remove the Camera from the
Mounting Base.
3. Screw two of the Mounting Base Unit Screws into the Mounting Base
and onto the ceiling/wall.
4. Insert the cable through the Mounting Base and connect the cable.
5. Screw the remaining two Mounting Base Unit Screws into the
Mounting Base to secure it on the ceiling/wall. Be sure that all
screws are tightened.
6. Align the Mounting Ring so that the arched area is above the IR
LED light. Make sure the Mounting Ring does not cover any part of
the IR LED light because it will reflect the light back into the
Camera during nighttime.
7. Location of the vari-focal lens adjustor.
FEATURES
INSTALLATION INSTRUCTIONS
Please read the Operational Manual
before attempting to use this product.
Yes No
DIMENSIONS
(
Unit: mm
)

EIVD36-42VF_rev04182008
Model EIVD36-42VF EOVD36-42VFP
TV System NTSC PAL
Image Sensor 1/3” Sony Super HAD CCD
DSP Sony
Total Pixels 510(H) x 492(V) 500(H) x 582(V)
Video Output 1 Vp-p 75 Ω(Sync Negative Polarity)
Resolution 420 TV Lines
Minimum
Illumination 0.5 Lux @ F1.2 (0 Lux @ IR “on”)
S/N Ratio More than 48dB
Electronic
Shutter Speed 1/60~1/100,000sec 1/50~1/100,000sec
Synchronization Internal
Gamma Control 0.45
Gain Control Auto
White Balance Auto
Back Light
Compensation On/Off Switchable
IR LED 36 IR LED
IR Wavelength 850nm
IR Working
Distance 82~98ft / 25~30m
Lens 3.5mm~8.0mm Vari-Focal Lens
IP Rating Weatherproof IP65
Power Supply 12V DC
Power
Consumption 300~450mA IR LED "on" 90~110mA IR LED "off"
Operation
Temperature -10oC ~ +50oC
Dimension 130mm(D) x 100mm(H)
Weight 1100g
* Specifications subject to change without notice
FCC NOTICE:
This equipment has been tested and found to comply with the limits
for a class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a
commercial environment. This equipment generates radio frequency,
and if not installed and used in accordance with the instruction
manual, may cause harmful interference.
ADDITIONAL CAUTIONS:
zBe careful not to shake the camera.
zPlease avoid places where direct sunlight may shine on the
camera.
zPlease avoid places where there are frequent vibrations or
shocks.
zPlease avoid places where the temperature exceeds 50oC or
temperatures lower than -10oC.
zPlease avoid storing and operating the camera in water.
zPlease avoid water spills on the video connectors and the DC jack
connectors.
zOne (1) EIVD36-42VF Camera with power/video cable
-One (1) Camera
-One (1) Mounting Ring
-One (1) Mounting Base
zFour (4) Mounting Base Unit Screws
zFour (4) Wall Anchors
zOne (1) Allen Wrench
zOne (1) Operational Manual
1. Never point the camera toward the sun
Do not expose the lens directly to the sun or to strong light as this may
damage the pick-up device.
2. Handle this camera with care
Avoid any shock or bumping of the camera. Improper handling could
damage the camera.
3. Requires a proper operating environment
This camera is designed for outdoor or indoor use. The allowable
temperature range for operation of this camera is between
-10°C ~ 50°C and the allowable humidity is 85%RH maximum.
4. Clean the front face to the pick-up device
It is recommended that the pick-up device surface be cleaned before
lens installation or whenever the lens is changed. Cleaning should be
done by using a chamois, a very fine soft cloth, lens tissue, or cotton
tipped applicator and ethanol to carefully remove any fingerprint or
dust.
5. Check the power source voltage
The power source voltage should be within the specified range.
(Camera must meet the specifications). Camera must be connected to
a surge protector at all times.
6. Objects and liquid entry
Never push objects of any kind into this camera as this may touch
dangerous voltage points of short out parts that could result in a fire
or electric shock. Never spill any kind of liquid on the video product.
7. Servicing
Do not attempt to service this video product by yourself as opening or
removing covers may expose you to dangerous voltage or other
hazards. Refer all service to qualified servicing personnel.
8. Damage requiring service
Unplug this video product from the wall outlet and refer service to
qualified servicing personnel under the following conditions:
a. When the power supply cord or plug is damaged.
b. If liquid has been spilled, or objects have fallen into the video
product.
c. If the video product has been dropped or the cabinet has been
damaged.
d. When the video product exhibits a distinct change in
performance.
This product is covered under warranty for one year from the date of
purchase. The warranty will automatically be voided if any of the
following occurs:
1. Camera sticker is removed
If the camera sticker is removed, we will not be able to confirm any
information regarding when and where the product was purchased.
We have no other way to verify the purchase record without the serial
number on the camera sticker; therefore, it should not be removed.
2.
Camera is modified in any way
If the camera is scratched, damaged, or modified in a manner not
described in this manual, the warranty will be voided immediately. It is
the customer’s responsibility to keep the camera in good condition.
3.
Video or power cable is cut
The video cable and the power cable should not be tampered with.
Cutting or modifying of the cables will result in termination of the
warranty.
CAUTIONS
WARRANTY
SPECIFICATIONS
SPECIFICATIONS