OLG Modulus Flip Table User manual

TOOLS REQUIRED: Powered screwdriver
Installation Guide
myocelinkgroup.com
Modulus Flip Table

Recommended
-person Step
STEP 2: Fully tighten 2 small screws into the cross tube.STEP 1: Place the pull bar (a) and cross tube (b) in the correct location pictured
above, slide the 2 end legs in place
* To prevent possible scratches or damage,
assemble the table upside down on a soft surface
such as a blanket, carpet or packaging.
* Attach Leg to the Top assembly by using Bolts,
spring washer, flat washer. Tighten using the
Allen Wrench provided.
MODULUS FILP TABLE
Installation Guide

STEP 5: On all tables with width larger than 700mm, secure the pull bar with
the supplied washer and screw in the location pictured above (slot end
closest to the pull-bar). Leave screw 1 turn from tight so the pull-bar
can be operated smoothly.
STEP 4:
Fully tighten all 6 screws on each mechanism.
STEP 3: Ensure the frame is located in the centre of the worksurface.
COMPLETE: Using  people rotate table into upright position.
MODULUS FILP TABLE
Installation Guide
Recommended
-person Step

MODULUS FILP TABLE - CONNECTORS/LINKS
Installation Guide
Drilling Patterns for Optional Connectors/Links
73200
17
17
20073
17
1.2mm pilot hole
17
CL
36.5 36.5
UnlockedLocked

MODULUS FLIP TABLE
Installation Guide
170mm
C
114mm
B B
138mm 138mm64 64
A
2x 2mmØx12mm h
12x 2.5mmØx15mm h
25mm
Table Length
Table Width
294mm
Drilling Patterns for Modulus/Uni Flip Tables Mechanism & Pull Bar
Width-600mm A B C
1200mm 796 96 NA
1500mm 1096 96 NA
1800mm 1396 96 NA
Width-900mm A B C
1200mm 796 246 175
1500mm 1096 246 175
1800mm 1396 246 175
Width-750mm A B C
1200mm 796 171 100
1500mm 1096 171 100
1800mm 1396 171 100