OLG Balance User manual

Balance Project with Arms
Assembly Instructions

Balance Project with Arms Assembly Instructions
2
Components List
Balance Project with Arms
Base
Back Frame
5 x Caster
Left Arm
Hex Wrench
Right Arm
4 x Short Bolt
Seat Pan
2 x Long Bolt
Gas Cylinder
F
A
G
B
H
C
J
D
K
E
A
B
C
D
E
F
G

Balance Project with Arms Assembly Instructions
3
Assembly Instructions
Balance Project with Arms
E
F
G
J
D
J
JJ
STEP 1: STEP 2:
G
Align back frame with pre-located holes
on the seat mechanism

Balance Project with Arms Assembly Instructions
4
Assembly Instructions
BC
KK
STEP 3: STEP 4:
Balance Project with Arms

Balance Project with Arms Assembly Instructions
5
Assembly Instructions
Slip Cover (sold separately)
1. Assemble chair Remove old slip cover and foam from seatpan by
unfastening the velcro fasteners on the back and
front of seat. Remove the back fasteners fi st.
2.
Make sure all four slip cover corners match to
the foam corners, top & bottom. Close zipper
approcimately 2”
5. Align 2 front corners and install using velcro
fasteners. Lift back of seat and zip up slip
cover. Align 2 back corners and install using
velcro fasteners.
6.Install new slip cover onto the foam.5.
Unzip old slip cover and remove from foam.3.
Balance Project with Arms

Sydney 02 8188 2732
Melbourne 03 9111 0315
Brisbane 07 3733 1923
Adelaide 08 7111 0810
Perth 08 9468 2707
info@olgoffice.com
myolg.online | olgoffice.com | officedesigner.net | motionoffice.com