On-Hold Plus OHP-4500 Assembly instructions

For technical support call [phone]
On-Hold Plus
Corded Phones
Cordless Phones
TRIGGER
12V DC
POWER
ON
OFF
AUDIOINAUDIO OUTVOLUME
PHONELINES
1/2/33/4
Connect to Analog Phone Lines
step
1
Connect TEHMA to Phones
step
2
System Test
step
3
Plug the supplied "T adapter" into any modular
phone jack which services line 1 and 2.
(This will allow you to share the phone jack with any phone extension
which you have plugged into the wall jack.)
Plug the provided phone cord into the jack marked
"Line 1/2/3" on the back of the player.
Plug the other end of the phone cord into the "T"
adapter which is servicing line 1 and 2.
REPEAT ABOVE IF LINE 3 and/or 4 ARE PRESENT.
NOTE: One unit will provide on-hold audio capability
to all phone extensions in your office.
IMPORTANT! Set volume control at half-way point.
Excessive volume will cause the on-hold audio to shut
off during playback.
Remove coiled handset cord from base of phone.
Plug short phone cord (supplied) into the "hold music activator"
(side marked "A") and other end to phone base.
Plug end of coiled cord (connected to handset) into jack on the
hold music activator (side marked "B").
NOTE: If after conecting you are unable to hear the dial tone,
switch the polarity switch on the side of the TEHMA.
Using the “cordless phone adapter cable (male)," plug
the end of the cable with the phone connector into the
jack on the hold music activator marked “to phone”.
Connect the headphone jack side of the cable to the
cordless phone’s headset jack.
Using the “cordless phone adapter cable (male)" connect
the phone connector to the jack marked “to handset”
Plug the headset into the female jack at the other end
of adapter cable.
3
2
1
3
2
1
3
4
2
1
3
4
2
1
From any phone in the office with a "hold music activator" attached, dial the phone number of another phone (2nd
phone in office or outside line).
Place the call on-hold using the HOLD button on the telephone.
Return to call and confirm that the on-hold audio was present on the line while on-hold.
Using the volume control on the rear of the player, adjust the volume to proper level. NOTE: Excessive volume may
cause the on-hold audio to shut off during playback.
Deactivating hold music manually
If for any reason the hold music is activated inadvertently, it can be deactivated by pressing any key on your phone's
dial pad.
Activating hold without a TEHMA
Phones without activators are able to engage the hold music feature by pressing the * * (star key twice) on the
telephone keypad and then immediately pressing the HOLD button on the phone.
Quick Connect Guide
The wiring in the handsets of GE 9450 and GE
9460 phones is reversed and your TEHMAs will
require a special crossover cable to work.
If you have either one of these phones,
please call 858-320-6737.
NOTE
GE 2-9450 & 2-9460 Phones
A B
TEHMA
P4/2
A B
TEHMA
P4/2