PREPARTION
1.Check the switch of the handle/skateboard in place,as the diagram:
A.Make sure that the Skateboard Power switch in off state.
B.Put the switch of “slow/fast”model to “Slow”mode on the handle.
C.Ensure the remote control was fully charged.
2.The Skateboard should be fully charged before first use.
REMOTE CONTROL DIAGRAM
1.Power Switch
2.MINI USB Charging Port
3.Start/Brake switch
4.Speed switch (Slow/Fast)
5.Direction switch (Forward/Backward Key)
6.Backward Indicator/Charging Indicator
7.Forward Indicator
8.Reset
When the handle can’t use or invalid,click on “Reset” to make it work(ensure the remote control
has power).
POWER INDICATOR
The remote control is build-in Li-polymer battery,when it’s low power the red indicator will flash
and with “Beep”alarm,you should turn off the skateboard and charge the remote control.
Please stop use the remote control when it's low charge.
1
2
3
4
5
6
7
8
k
has power).
c
has power).
N
has power).
O
has power).
E
has power).
R
has power).
A
has power).
R
has power).
T
has power).
P
has power).has power).has power).
P
has power).
e
has power).
1
has power).
.
has power).
C
has power).
h
has power).
I
has power).
