OPT7 AURA INTERIOR User manual

INTERIOR
INSTALLATION GUIDE
LIGHT STRIPS
TM
MAIN COMPONENTS
AURA CONTROL BOX HAND HELD REMOTE
MOUNTING KIT
EXTENSION WIRES CIGARETTE LIGHTER POWER ADAPTER
Off
AUTO
On
S+
S-
M+
M-
321

INSTALLATION
Decide where to locate the light
strips and ensure wiring has enough
length for control box to be installed
in desired location.
STEP 1
Once connected, plug the control box Cigarette Power Adapter into an available
12 volt charging port.
CIGARETTE POWER ADAPTER12 VOLT CHARGING PORT
1.
2.
Connecting to more than 10 AMP will override the kit and cause early failure,
ensure it is 10AMPs or less!!
Please ensure that the LED bars or strips/control box/wiring all are mounted
in areas where will not exceed 85℃or 185℉.
WARNING
As shown below, connect all light strips to the control box with the included
extension cables.
EXTENSION WIRE LIGHT STRIP

INSTALLATION
Thoroughly clean the surface where you plan
on mounting the LED strip with rubbing /
isopropyl alcohol. (This part is essential for a
rm and long lasting placement.
A dirty surface will prevent the strip from attaching firmly. Peal the double-sided tape and
firmly press the LED strip to the mounting area and hold for 3 seconds. Then, use the
zip-ties to tie all the wirings away from all moving components.
STEP 2
STEP 3
Secure Control box in desired location
with Velcro or zip ties.
* CONTROL BOX NOT WATERPROOF
Ensure the control box is safely and securely hidden from
exposing elements of moisture.
Note the
direction of
the arrows
BE SURE TO CONFIRM THE CORRECT DIRECTION OF THE ARROW!!
TO AVOID PRODUCT DAMAGE DUE TO INCORRECT INSTALLATION.
CORRECT INSTALLATION
IMPORTANT
! !
Flow direction

DISCLAIMER
OPT7 Lighting is not liable for damages or personal injuries while installing this
product. The Installation Guide is intended as assistance to reduce setup time.
OPT7 Lighting assumes no responsibility for improper installation.
If you are unfamiliar with your vehicle or inexperienced with aftermarket
upgrades, please seek professional assistance.
OPT7 recommends installation for safety and guidance.
Modified installations or installation recommendations not specified by
OPT7 Lighting will void product warranty.
Using the included 21Key E-Z Remote, select your desired
color or pattern.
( Note: When you use this product, keep it within
10m/33ft as much as possible )
STEP 4
Off
AUTO
On
S+
S-
M+
M-
321
Power
Automatic Color Change
Power
Speed
Mode
Dimmer
Color Selection
SoundSYNC
ON
OFF
9 Levels
3 Modes
9 Levels
9 Colors
3 Modes
1 2 3
4
7
8
5 6
1
2
3
4
7
8
5
6