
Step 1 - Scan Bluetooth mode
Scan the Bluetooth Default barcode that matches the
connection method you wish to use. The recommended
mode is HID or HID for iOS, depending on the device
you are pairing with. HID for iOS allows the onscreen
keyboard to be toggled with the function key. The
other mode is SPP or SPP for iOS and will require an
application on the target device.
Step 2 - Hold the function key for 5 sec
Hold the function key for 5 seconds until it beeps and
begins to flash blue. The OPN-3102i is now discoverable
by your host device. This can be cancelled at any time
by holding the function key for another 5 sec.
Step 3 - Perform Bluetooth search on host
Use the Bluetooth interface on your host device to
search for and select the OPN-3102i. The device will
beep to indicate success or failure. If you are pairing in
Bluetooth-SPP or Apple MFi mode, the OPN-3102i will
complete the pairing process as soon as you launch an
appropriate application (i.e. OPNTerm for iDevices) and
open the serial port created by your Bluetooth software.
If your host device does not support Simple Pairing, then
you may use the barcodes at left to input a PIN code.
Bluetooth Disconnect / Reconnect
• When connected, a Bluetooth connection can be
broken by holding the trigger key for 5 seconds.
• When disconnected, a Bluetooth connection can
be reestablished by holding the trigger key for 5
seconds. Barcode data stored when disconnected
will be automatically transmitted.
For information, including detailed setup instructions,
downloads and more, visit us at:
www.opticonusa.com/start/opn or
www.opticon.com/downloads
Quick Start Instructions
9
8
6
5
4
3
2
1
0
7
Pine
_PINE_
_QSG_OPN-3102i_07w.2021OPN31029082-0-00