4EN
1.3 Electrical safety
• Before connecting the appliance to the power supply for the first time, make
sure that the voltage on the appliance label corresponds to that of the
household electrical socket.
• The electrical appliance is designed for mains supply 230 V ~.
The electrical safety of the appliance is guaranteed only if it is properly
connected to the electricity grid.
• Only use a power cord with a plug (mains lead) that came with the device
and compatible with a wall socket. Using another cable may result in fire or
electric shock.
• Always connect an electrical appliance to an easily accessible power
socket. In the event of an operating fault, the appliance must be switched
off as soon as possible and disconnected from mains supply.
• Do not pull the power cord / power cord by pulling on the cord / cord.
Disconnect the power cord by pulling the plug behind the power cord /
power cord plug.
• If you use an extension cord, check that the total rated (ampere) power of
all devices connected to the extension cord does not exceed the maximum
current rating of the extension cable.
• If you need to use an extension cord or power supply block, make sure that
the extension cord or power pack is plugged into a power socket, and not
to another extension cord or power supply. Extension power cord or power
supply block must be designed for grounded plugs and plugged into a
grounded socket.
• The power plug of the appliance must be compatible with the mains socket.
Never use any adapters or modify the socket in any other way. Do not use
inappropriate or damaged soclets.
• To avoid electrical shock, plug the power cables into properly grounded
electrical sockets. If the device is equipped with a 3-pin power supply cord,
do not use adapters that do not have a grounding element or remove the
grounding element from the plug or adapter.
• Do not bend, crush or otherwise expose the power cord / power cord of the
appliance to mechanical stress or external heat sources. Damage to the
power cord may result in electric shock.
• If the power cord is damaged, disconnect the appliance from the mains and
do not use it again. If the power cord / power cord is damaged, it must be
replaced by the manufacturer, its service department, or a qualified person
to avoid the risk of electric shock.
• Regularly check and maintain the electrical appliance as well as the
power cable. Disconnect the power plug regularly and clean it if necessary.
Pollution by dust or other substances may cause disruption of the insulating
state and consequently fire.
• Do not expose the appliance to water or moisture. The ingress of water into
the appliance increases the risk of electric shock. If the power cord is wet
or the appliance gets water, disconnect it immediately from the mains. If the
appliance is plugged into a mains socket and if possible, turn off the power
supply before attempting to disconnect the power supply. If you are pulling
wet wires from a live power source, be very careful.
• If the electrical equipment is installed (connecting) the protective covers are
dismantled, the electrical parts must not be accessible to the user when the
installation is finished.
