Orbita Rotorwind Avanti 9 Manual

All battery operated AVANTI winders are fitted with high-energy, factory
installed, LITHIUM batteries that provide several years of battery life. In
addition, each AVANTI winder carries an iron-clad 2-year product guarantee.
Replacement
When the time comes to replace the Lithium batteries in your AVANTI
winder, you may purchase replacements directly from us. You may also
purchase locally if available. Should you purchase locally, be sure to change
all the batteries at the same time.
INSTRUCTION GUIDE
6740 Netherlands Dr.
Suite. D
Wilmington, NC 28405
www.orbita.com
Orbita Lithium Batteries
Give Us A Shout!
Need a different size cushion? We have smaller and larger size cushions
available for purchase direct from our website at: store.orbita.com, or call our
toll free 800 number (below) and we will be happy to assist you.
Online
www.orbita.com
Customer Support
Made in USA
Email
[email protected]
Phone / Fax
910-256-5300 / 910-256-5356
9
Toll Free
800-800-4436

1. Avanti 9
2. Key (1)
2. Cup Assembly (9)
3. Standard Cushion (9)
4. Lithium Batteries (8)
5. Warranty Registration
6. Instruction Book
Turning Power On
1. Carefully unwrap the protective packaging.
2. Remove the key that is taped to the glass door.
3. Unlock and open the doors.
4. Select 8 or 12 minute setting. (Details on Next Page)
5. Mount watch on cushion and slide cushion into cup.
6. Slide the cup back firmly to engage the drive shaft key.
7. Turn the power on using master power switch(es) (o/-).
Included In This Box 8/12 Minute Switch
Battery Removal
Mounting Watch on Cushion
Avanti 9 + 12 Lithium Modules
Getting Started
1. With the bracelet or strap of the watch closed, squeeze and slide the
cushion through the watch. The back of the watch should rest against the
Orbita logo and the strap should lie on the flat portion of the cushion .
A program switch located behind the cups
allows you to select one of two winding
cycles: 8 minute (factory preset) or 12
minute (Extended program). The winding
cycle begins every 8 or 12 minutes based on
the program selected. Many watches that
wind in both directions stay fully wound on
the factory preset 8 min setting. To select the
extended program, remove the mounting
cup to reveal the program switch opening.
Insert a small object (screwdriver, pencil,
etc) into the opening and slide the switch to
the 12 minute setting. The factory preset
position is the 8 minute setting.
Congratulations!
The Avanti user guide will help take you though the initial set up and program-
ming of your new watchwinder. Your Avanti is factory-fitted with ORBITA
Lithium "D" cell batteries which provide years of operating life at the normal
8-minute winding cycle. Even longer life may be accomplished by using the
12-minute mode pending upon the watch’s winding characteristics.
To access the Lithium batteries
on the rear of the watchwinder,
remove the small Phillips head
screws on the battery compart-
ment tabs. Push the tabs down
and pull compartment doors
open.
12
8