Oricore ST-66 User manual

S-037A-1-1
User Guide
Bluetooth Headset ST-66

LCD
Last Page
Next Page
16
17
18
18
19
20
22
24
24
24
25
26
27
28
28
29
Activate/inactivate caller ID
25
Jack

Battery Power Indicator(Full is fully charged)
Battery Power Indicator(half filled is half charged)
Battery Power Indicator(Blank is consumption up)
Displaying Power on
Displaying power off
Connection Status Indicator
LCD Displaying the Current Status When Dialing Call
LCD Displaying the Current Status When a Call is Coming
First plug the plugger into the recharging hole(fig.2)Јthen connect
the recharger into the A/C socketЈthe LCD will display on the OLED
Charging......
Fully recharging needs 2h long. afterwards the battery LCD will displaying
fully filledЈ LCD displays Charging complete afterwards unplug the
earphone from the A/C socketЈ
Ready

Short press MFB button (fig. 1)until a beep is heardЈ when LCD will display Power on
Afterwards the display will shift to Connecting to connect with the last paired deviceЈ
after successfully pairedЈLCD will display Connected Јif failed to pairЈ LCD will display
Ready
In power on statusЈ long press MFB button for 5 seconds until a beep is heardЈafterwards
LCD will display Power off
If the earphone is left unused for a certain periodЈ the earphone will be supposed to inactivate
the Bluetooth function
Attention

Long press MFB button for 5 second until 2 beeps is activeЈwhen LCD displays pairing
AttentionЈIn pairing statusЈif u want to cancel the connecting statusЈlong press MFB
button for 5 seconds to exit
When a call is coming Јthe ring tone will be heard(if the buzzer is availableЈthe
continuous beeps will be active.If the earphone activate the called ID displaying
functionЈthen the caller ID will display on the LCD screenЈif notЈthen LCD will
display only Incoming call)
Press MFB once to answer the coming call.If you use the cellphone to answer the
coming callЈLCD could display the call time-lengthЈDuble press MFB button to
reject the coming callЈ
Answering/Rejecting call

Synchronizedly press Volume + and Next page for 5 seconds until Reset headset
displays on the OLED screen with two beeps, afterwards the earphone is power off and delete
the pairing status. After power on, the earphone will activate only after re-pairing.
Mute
Delete the Pairing Status
In communication mode,double press MFB button to mute the mic.In mute mode,double
press MFB button to reactivate the mic with synchronized two beeps from the earphone.

Activate/inactivate caller ID
Short press Last pageuntil a beep is active,when ALL ID On is displaying on the OLED
screen.
In caller ID displaying mode,repeat the above procedure to inactivate the caller ID displaying
function, thenCALL ID OFF is displaying on the OLED screen.
In caller ID activate mode, when a call is coming ,caller ID is displaying on the OLED screen.
In caller ID inactive mode,when a call is coming , Incoming callis displaying on the OLED
screen.
Turn off the Built-in Buzzer
Press the Next page for 5 seconds until the buzzer beeps 2 times, then turns off the buzzer.
When a call is coming , the tone is still heard through earpieces.

2400.0-2483.5MHz