
(c) 2012 Orion Robotics. All Rights Reserved. 2
Odyssey Assembly Guide
Introduction
All our brackets are made in the USA. They are fabricated using a large in house industrial laser. We
anodized all our brackets to prevent corrosion and to give them that shinny new robot look. Anodizing
also keeps the brackets looking better longer.
Servos
The Orion Robotics robots are built around a special robotics servo developed in house. These new
servos give us greater control and the ability to further push the envelope of what these robots can do.
In addition the custom servos allow us to better control cost.
Tools
There are some basic tools you will need to get started. A good set of Phillips screw drivers and small
pliers. Typically needle nosed pliers work best.
Safety
When working with robots some basic safety rules should be followed:
1. Eye protection should be worn at all times.
2. Some bracket edges can be sharp and can easily cut you.
3. The robots are powered from Lion batteries with high discharge rates. If shorted or incorrectly
connected the can easily cause re or other damaged.
4. When working with the robots there are several pinch points. Be aware as this will hurt.
5. Don’t be in a rush when assembly your robots. Injury or damaged parts can easily result. Take your
time and double check each step.