Osburn EVEREST II Installation and operating manual

OSBURN-OB04016-EVEREST II — ZC WOOD FIREPLACE QUICK INSTALL/REFERENCE GUIDE
Listed to UL 127 and ULC-S610 Standards
Page 1
(08-2020)
THIS QUICK REFERENCE PRODUCT SHEET IS NOT COMPLETE AND IS SUBJECT TO CHANGE WITHOUT NOTICE.
ALWAYS REFER TO OWNER'S MANUAL ACCOMPANYING THE PRODUCT TO AVOID RISK OF FIRE AND INJURIES.
ADDITIONAL INFORMATION CAN BE FOUND IN THE OWNER'S MANUAL ONLINE AT WWW.OSBURN-MFG.COM
APPLIANCE DIMENSIONS FRAMING DIMENSIONS
CORNER INSTALLATION
LEGEND
Combustible
material allowed
in this area
Non-combustible
material only
in this area
* Where applicable, add 12’’ for fresh air pipe
and/or 18’’ for forced air pipe to the width
of the chase. When drywall panels or any
other finishing material inside the chase around
the fireplace is to be used, add its thickness
to the measurement.
** For height equal or less than 4’’, see hearth
extension section on reverse.
14 3/4"
376 mm
49 1/8"
1247 mm
45 7/8"
1166 mm
30 3/8"
770 mm
3 7/8"
100 mm 15"
380 mm
2 1/2"
64 mm
31 1/8"
790 mm
41 3/4"
1060 mm
20 7/8"
530 mm
6 "
152 mm
17 "
430 mm
10 5/8 "
270 mm
13 1/2
"
341 mm
10 7/8
"
276 mm
9 3/4
"
248 mm
11 3/8"
290 mm
9 3/8"
237 mm
30 3/8"
770 mm
3 7/8"
100 mm
15"
380 mm
24"
609 mm 28 5/8"
727 mm
54 7/8"
1394 mm
77 5/8"
1972 mm
54 7/8"
1394 mm
18 1/4"
463 mm 18 1/4"
463 mm
COMBUSTIBLE
VARIABLE
24 1/2"
622 mm
423/4"
*
1086 mm
MIN.
NON-
COMBUSTIBLE
COMBUSTIBLE
COMBUSTIBLE
49 1/2"
1257 mm
VARIABLE**
80"
2032 mm
NON-
COMBUSTIBLE
This space must
remain empty

OSBURN-OB04016-EVEREST II — ZC WOOD FIREPLACE QUICK INSTALL/REFERENCE GUIDE
Listed to UL 127 and ULC-S610 Standards
Page 2
(08-2020)
THIS QUICK REFERENCE PRODUCT SHEET IS NOT COMPLETE AND IS SUBJECT TO CHANGE WITHOUT NOTICE.
ALWAYS REFER TO OWNER'S MANUAL ACCOMPANYING THE PRODUCT TO AVOID RISK OF FIRE AND INJURIES.
ADDITIONAL INFORMATION CAN BE FOUND IN THE OWNER'S MANUAL ONLINE AT WWW.OSBURN-MFG.COM
HEARTH EXTENSION CONSTRUCTION AND DIMENSIONS
LEGEND
FACING MATERIAL SHELF, MANTLE, AND WALL PROJECTION
OPTION #1 OPTION #2
OPTION #3
Non-combustible
floor protection
Non-combustible
material only
in this area
Non-combustible
floor covering
Combustible
material allowed
in these areas
Floor covering
Floor protection
Where R-value is required,
refer to manual for
equivalent insulation.
Where R-value is required,
refer to manual for
equivalent insulation.
Raise base of 4" or less:
R-value required: 1.00 or greater
Raise base of more than 4":
No R-value required
B
B
45°
C
C
80"
2032 mm
48"
1219 mm
80"
2032 mm
* Clearance may be
reduced by use of
approved heat shield.
See Owner’s manual.
No combustible
material in this area
3"
76 mm
8"
203 mm
21"
533 mm
45°
≤ 4"
101,6 mm
16"
406 mm
2"
51 mm
2"
51 mm
8"
203 mm
36 3/4"
933 mm
16"
406 mm
8"
203 mm
2"
51 mm
2"
51 mm
36 3/4"
933 mm
> 4"
101,6 mm
16"
406 mm
2"
51 mm
2"
51 mm
2"
51 mm
2"
51 mm
36 3/4"
933 mm
8"
203 mm
Le matériaux non-combustible doit couvrir la façade du foyer
jusqu'à une hauteur minimale de 70" (1777 mm).
70"
1777 mm
33 1/4"
844 mm
4"
102 mm
4"
102 mm
POSITIONING AND DEPTH OF THE THE SHELF
B48" (1,21 m) 50" (1,27 m) 52" (1,32 m) 54" (1,37 m)
C6" (152 mm) 8" (203 mm) 10" (254 mm) 12" (305 mm)
Directly on the floor:
R-value required: 1.00 or greater