Otto WF307277 User manual

Sideboard
Dimensions
Width - 58inch
Depth - 15.7inch
Height - 25.2inch
Issue 1 - 05/31/23
Wichtig – Bitte lesen Sie diese Anleitung vollständig durch, bevor Sie mit der Montage beginnen
Important – Please read these instructions fully before starting assembly
Assembly Instructions / Montageanleitungen
WF307277 / WF307278
Größe
Breite - 147.3cm
Tiefe - 40cm
Höhe - 64cm

Safety and Care Advice
Important – Please read these instructions fully before starting assembly
• Check you have all the
components and tools listed on
the following pages.
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
Care and maintenance
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
• This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Handy Hints
• Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the bolts
• Regularly check and ensure
tightend properly.
• During assembly do not stand
or put weight on the product,
this could cause damage.
• Assemble the item as close
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
• Parts of the assembly will be
easier with 2 people.
• To reduce
the likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
WARNING
In order to help prevent overturning –
To help prevent product toppling over please follow the below steps:-
Do not open more than one drawer at a time
Do not place heavy items in the top drawers
Do not place heavy items on top of the furniture, unless the furniture has been
designed for this purpose
You will need to provide wall plugs and screws applicable for your wall type
1
!
• Remove all fittings from the
to its final position (in the same
unit or your floor.
That all bolts and fittings are
please follow these instructions
Do not allow children to climb or hang on the furniture
Use the anti tip stap or wall fixing method provided (if applicable)
please note that only the anti tip strap is provided.

Male Camlock x 14
A
D
Female Camlock x 14
B C
Dowel x 18
E
6*50mm Screw x 6
F
G H I
6*12mm Screw x 8
J K
3*16mm Screw x 16
M
3.5*14mm Screw x 40
N
Plastic pivot x 8
O
L
Plastic wedge x 8
R
Q
P
Door Hinge x 4
Door Hinge x 4
Wall Fixing Pack x 2
S
3*12mm Screw x 8
T
Ø20 Sticker x 6
Hex Key M4 x 1
4*14mm Screw x 4 Handle x 4
Magnet Touch x 4
Legs x 4
Middle Leg x 1
Components - Fittings / Komponenten - Beschläge
Notiz:
Bitte überprüfen Sie, ob Sie alle unten aufgfüehrten Panels haben
Die folgenden Mengen sind die richtige Menge, um die Montage abzuschließen. In manchen Fällen
werden mehr Fittings geliefert als benötigt werden.
Please check you have all the panels listed below
Note:
may be supplied than are required.
The quantitie below are the correcet amount to complete the assembly. In some cases more fittings
Tools required / Werkzeuge benötigt
Kreuzschlitzschraubendreher
(mittel und groß)
Lineal - Verwenden Sie dieses Lineal, um die Schrauben richtig zu identifizieren
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 105 110 115 120 125 130 135 140 145 150 155 160 165 170
Die Schraubenlänge wird vom Kopf bis zur Spitze gemessen (30-mm-Schraube abgebildet).
Ruler - Use this ruler to help correctly identify the screws
Phillips screwdriver
(medium & large)
The screws length is measured from the head to the point (30mm screw shown).

Using Camlocks
12
DO NOT OVER TIGHTEN.
NE PAS SERRER EXCESSIVEMENT.
34
4
Step 1
Step 3
Step 2
Step 4
Connect the male
camlock as diected in
the assembly instructions
using a scewdriver.
Push the male camlock
into the entry hole.
Insert the female
camlock as shown in the
instruction.
Note：ensure that the
arrow on the top of the
camlock points towards
the entry hole for the
male camlock.
Turn the female camlock
clockwise with a
screwdriver.
You should feel a click
when the camlock is
locked in place.
The joint is now secure.
Verwendung von Camlocks
12
DO NOT OVER TIGHTEN.
NE PAS SERRER EXCESSIVEMENT.
34
4
Schritt 1
Schließen Sie das
männliche Camlock gemäß
den Anweisungen in der
Montageanleitung mit einem
Schraubendreher an.
Schieben Sie das
Männlicher Camlock in das
Eingangsloch.
Setzen Sie das
Femalecamlock wie in
der Anleitung gezeigt
ein.
Hinweis: Stellen Sie
sicher, dass der Pfeil
auf der Oberseite des
Camlocks auf das
Eintrittsloch für den
männlichen Camlock
zeigt.
Drehen Sie die
Weibliches Camlock mit
einem Schraubendreher
im Uhrzeigersinn.
Sie sollten ein Klicken
spüren, wenn der
Camlock eingerastet ist.
Das Gelenk ist jetzt
siche
Schritt 2
Schritt 3 Schritt 4