Outdoor Gourmet 157872 Owner's manual

Please keep thisinstruction manual for future reference
Customer Service: [phone], 7:00 am to 12:00 am daily CST
Live Chat on Academy Website (www.academy.com) 24/7 or email
[e-mail]
(Made in China)
Assembly Instructions
& User’s Manual
Outdoor Gourmet Gas and Griddle Combo
Model #: 157872

Page 2 of 32
Table of Contents
Note: Before beginning assembly of product, make sure
all parts are present. Compare parts with package content
list and hardware contents. If any part is missing or
damaged do not attempt to assemble the unit. Contact
customer service for replacement parts.
...................................................................12-23
.............................................................28-30
...................................32
7
8-9
10
11
...................................................................24-27
Operating Instructions
................................................................... 27
Trouble Shooting...... ......
...........................................................
Frequently Asked Questions 31

Page 3 of 32
1.
2.
3.
4.

Page 4 of 32
Do not store a sapre LP-gas cylinder under or near thiis appliance;
Never fill the cylinder beyond 80 percent full; This may cause release of gas from the safety release
valve;
If the information in "(1)" and "(2)" is not followed exatcly, a fire causing death or serious injury may occur.
8.
Griddle installation must conform with local codes,or in their absence,with either the National Fuel
Gas Code,ANSI Z223.1/NFPA 54,Natural Gas and Propane Installation Code,CSA B149.1,or
Propane Storage and Handling Code ,B149.2.
Griddle,when installed,must be electrically grounded in accordance with local codes,or,in
the absence of local codes,with the National Electrical Code,ANSI Z21.58-2018,or the Canadian
Electrical Code,CSA 1.6 -2018.
This Grill is intended for outdoor use only,and should not be used in a building,garage,or any
other enclosed are.
This Grill is not intended to be installed in or on recreational vehicles and/or boats.
Never use any other type of fuel for this grill other than LP gas(propane).
Only use the pressure regulator with a type 1 connector that is supplied with this gas grill.
Before each use,check the gas hose for excessive abrasion,cracking,fraying,wear,or cuts.
Replace a hose assembly showing those signs with the hose assembly specified in the parts list
before using the grill.
Always perform a Leak Test before operating your grill.

Page 5 of 32
from
Place dust cap on cylinder valve outlet whenever the cylinder is not in use. Only install
the type of dust cap on the cylinder valve outlet that is provided with the cylinder
valve. Other types of caps or plugs may result in leakage of propane.
2. Do not store in a building,garage,or other enclosed area.
3. Always store your cylinder outside.
4. Store out of reach of children.
5. Always transprot in an upright position.
6. Do not smoke when transporting your cylinder.

Page 6 of 32
1. Do not connect this grill to any unregulated sources of propane.
2. Before each use,check the gas hose for excessive abrasion or wear,or cuts.Replace a hose
assembly showing those signs.The replacement hose assembly shall be that specified by the
manufacturer.Inspect the hose assembly underneath the side burner and following the regulator
hose up to its connection to the gas manifold assembly.
3. Always perform the Leak Test listed below before using your griddle for the first time,if the cylinder
has been changed,any gas components have been changed,the regulator flow-limiting device has
been activated,or after a long period of non-use.
4. Do not attempt to connect the grill to the LP system of a motor home or trailer.

Page 7 of 32
1. Ensure the LP cylinder valve and all burners are "OFF".
2. Ensure the LP cylinder is connected to the regulator.
3. If the information above is not followed exactly,a fire causeing death or searous injury may occur.
4. Mix a solution of 50% water and 50% liquid dish soap.Do not use any household cleaner solution.
5. Open the LP tank valve by turning the hand wheel counterclockwise ont turn.If you hear a rushing
sound,turn the gas off immediately.In that case,there could be a leak at the connection.Reconnect
the cylinder to the regulator.
6. Spray or brush on the solution covering the following areas:Cylinder welds,regulator and cylidner
connection,gas hose connections to the regulator,all gas hose,all gas hose connections to the
7. Growing bubbles on any of the parts and connections listed aboce indicate a gas leak.Immediately
shut off the LP tank valve by turning the valve clockwise.Retighten the connections or order
replacement parts as needed.Continue to test as necessary until to leaks are derected.
8. Close the LP tank valve by turning the hand wheel clockwise.
burners including the main and side burners.

Page 8 of 32

Parts List
Page 9 of 32
Side Shelf 2PCS
1234
5678
910 11 12
13 14 15 16
17 18 19 20
21 22 23 24
25 26 27 28
Bottom Shelf 1PC Back Panel 1PC
Directional Caster 4PCS Tank Barrier Bar 1PC Fence Rail 1PC Door (R) 1PC
Door (L) 1PC Handle Base 4PCS Door Handle 2PCS Back Side Bracket (R) 1PC
Back Side Bracket (L)
1PC
Body 1PC Side Table Connector (I)
2PCS
Side Table Connector (II)
2PCS
Side Bracket (RF, LB)
2PCS
Side Bracket(LF, RB)
2PCS
Side Table (L)
1PC Side Table (R) 1PC
Flam e Tam er 3 PCS Cooking Grate 2PCS Drip Pan 1PC
Griddle Top 1PC Oil Cup 1PC
Tank Holder 1PC
Oil Tray 1PC Oil Tray Handle 1PC
WWWWWWarm ing Grate 1PC

Exploded View
Page 10 of 32

Hardware
Page 11 of 32
󰾡
BOLT M6
×12
(49 pcs)
BOLT M4
×8
(2 pcs)
BOLT M6
×55
(4 pcs)
󰾡
MAGNET
(1 pc)
󰾡
(8 pcs)
󰾡
COTTER PIN
(4 pcs)
Ø1.5x28
󰾡
GRIDDLE FOOT M6
(4 pcs)
󰾡
(4 pcs)
NUT M6 FLANGE LOCK
×30
BOLT M5
×10
(2 pcs)
󰾡
BOLT M6
×20

Assembly Instructions
Step 1:
Step 2:
Page 12 of 32
Insert Tank Holder (3) - 1 PC
to Bottom Shelf using COTTER
PINS (E) - 2 PCS.
- 1 PC to the legs using BOLTS
M4 X 8 (B) - 2 PCS.
Assembly the Side Shelf (1) - 2
PCS to Bottom Shelf (2) - 1 PC
using BOLTS M6 X 12 (A) - 4
PCS and M6 X 55 (C) - 4 PCS.
Install Magnet (D) -1 PC on
Bottom Shelf using BOLTS

Assembly Instructions
Step 4:
Step 3:
Page 13 of 32
the bottom assembly
Turn over
when complete and lock casters
to prevent from moving.
Install Directional Caster (5) - 4
PCS to side shelfs by twisting
until tight.
Install Back Shelf (4) - 1 PC
using BOLTS M6 X 12 (A) -
7 PCS.

Assembly Instructions
Step 5:
Step 6:
Page 14 of 32
Install Fence Rail (7) -1 PC to the
- 1 PC to the legs using BOLTS
(A) - 4 PCS.
side shelf using BOLTS M6 X 12
Install Tank Barrier Bar (6) - 1
PC using BOLTS M6 X 12 (A)
- 2 PCS.

Assembly Instructions
Step 7:
Step 8:
Page 15 of 32
Insert bottom-end of the door
into the hole of the base on the
bottom shelf as shown.
Insert upper-end of the door
into the hole of the fence rail
as shown.
Press upper-end of the door as
high as the bottom of the fence
rail as shown.
Install Door Handle (11) - 2 PCS
and Handle Base (10) - 4 PCS on
the Door (8)(9) using BOLTS M6
X 12 (A) - 4 PCS. 89

Assembly Instructions
Step 10:
Step 9:
Page 16 of 32
Put the Body (14) - 1 PC onto
the cart.
Install Back Side Bracket (12)(13)
-2 PCS to back side of cart using
BOLTS M6 X 12 (A) - 4 PCS as
shown.

Assembly Instructions
Step 12:
Step 11:
Page 17 of 32
Install Side Table Connector (I)
(15) - 2 PCS and Side Table
Connector (II)(16) - 2 PCS on
body using BOLTS M6 X 12 (A) -
8 PCS.
Lock Back Side Bracket to back
side of body using BOLTS M6
X 12 (A) - 6 PCS as shown.

Assembly Instructions
Step 14:
Step 13:
Page 18 of 32
Install Side Table on body using
BOLTS M6 X 20 (F) - 8 PCS.
Install Side Bracket (RF,LB)(17) -
1 PC and Side Bracket (LF,RB)
(18) on Side Table (L)(19) - 1 PC
using BOLTS M6 X 12 (A) - 4PCS.
Repeat step with Side Table (R)
(20) - 1 PC.

Assembly Instructions
Step 16:
Step 15：
Page 19 of 32
Place Flame Tamer (21) - 3 PCS
into Gas side of body.
Place Cooking Grate (22) - 2PCS
into body.
21
22

Assembly Instructions
Step 17:
Page 20 of 32
Step 18:
Slide Drip Pan (24) - 1 PC into
the Griddle Body.
Assemble the Warming Grate
(23) by inserting the top two
ends to gas lid and bottom
side to body. Secure the top
part of warming grate with
pre-assembled COTTER PIN
(E) - 2 PCS.
24
23
E