Outdoor Revolution Navigator Klassic User manual

Outdoor Revolution MODEL Navigator Klassic
Thank you for purchasing an Outdoor Revolution product, this product will give years
of satisfactory service if asic instructions are followed, our products are designed for
dura ility and for ease of erection .
Spare poles can e purchased to replace roken poles
** Porch awnings will not e swapped ecause of roken poles**
Please read the following instructions carefully
TIP: Refer to the photograph to help when pitching your Navigator Klassic.
•
••
• Please do not leave for your holiday without fully erecting and checking the contents of your
porch.
•
••
• Ideally erect your porch for some period allowing it to weather.
•
••
• Please make sure that before erecting, that you site the porch on clear Level ground with no sharp
objects underneath, and that all the ips are fully closed. (We recommend laying a groundsheet
down to keep the awning Dry and clean)
•
••
• If you have any issues relating to pitching your awning please contact your dealer for instructions
before going on holiday.
•
••
• Please note this awning is designed as a ‘touring’ awning and not for ‘permanent pitch’
use
IMPORTANT PLEASE CHECK YOUR EQUIPMENT
(Make yourself familiar with the awning and its parts before attempting to erect)
Contents
Flysheet (or outer)
steel poles (in a separate bag)
Pegs (in a separate bag)
Outer carrying bag (with dimension details)
Stability Straps
Groundsheet
A selection of spares

ERECTION INSTRUCTIONS.
Outdoor revolution tents are all erected outer first.
1. Lay the outer/flysheet spread out on the ground. Slacken adjusters off on the lack tapes (near the ring
and pin assem lies) around the foot of the awning.
2. Open the pole ag and lay the poles out on the ground. Take one of the shaped steel roof sections and
open it out, then slide it through one of the seams on the roof (taking care not to damage the seam) to
the other side of the seam. Next take one of the steel vertical legs and attach it to one of the Ferrell’s at
the end of the steel roof pole. Repeat the process at the other end of the fi re pole, complete this y
placing the steel pin on the ‘ring and pin’ assem ly into the foot of the steel pole. SPARE POLES CAN
BE PURCHASED FROM WWW.OUTDOOR-REVOLUTION.COM, spares section.
3. Guy lines can now e tensioned and pegged on the awning and canopy, please ensure in heavy weather
that ALL guy lines and sta ility straps are used. (Please note that failure to use all the lines may result in
your tent eing damaged)
4. You are now ready to ack your vehicle up to the Navigator Klassic. Offer up the ‘tunnel’ at the ack of
your awning to the desired position and secure the tunnel in place up to the roof of your vehicle, finally
tension the elastic toggles to create a etter weather seal.
***Note, to attach the movelite Navigator Klassic to a Motorhome Fiamma/Omnistor you will need to purchase a
driveaway kit consisting of dou le edged awning piping an figure 8 joining strips. Simply slide into the awning rail,
then the Awning is lined up and the figure 8 is positioned to join the two.
ADDITIONAL FEATURES ON YOUR NAVIGATOR KLASSIC
1) Inner tent
2) SS system
3) Sewn in groundsheet
4) Entrance Porch
Please note these few points for trouble free camping.
a. After use please you always dry and air the tent before packing away.
b. Any dirt or stains can be removed by brushing or gently washing with warm water. DO
NOT use detergents as this will destroy the waterproofing on the fabrics.
c. We advise that you DO NOT cook or smoke in this tent.
**We highly recommend that you insure your awning against storm
damage or accidental damage, as the warranty does not cover such
eventualities. The manufacturer is not liable for any damage caused
to the caravan or vehicle because of misuse, incorrect pitching or
extreme weather**
Outdoor Revolution Awnings are distri uted y:
Blue Diamond Products Ltd
WWW.Blue-diamond-products.co.uk