Installation Sequence:
1. 100-240VAC: (Adaptor -> Extension Cable(Option) -> Dimmer -> LED Lights)
2. 9-15VDC: (Car Lighter -> Extension Cable(Option) -> Dimmer -> LED Lights)
3. USB Power Source: (USB Extension -> Extension Cable(Option) -> Dimmer -> LED Lights)
4. LED Lights can be use singly or connected in gangs of two or three.
Warning:
1. Shut off power before installation;
2. Before using remote, please take away the battery isolator spacer tab.
3. When installing, please take special care to place cables neatly to avoid any trip hazard.
4. For inside use only.
5. If the tube lights show any signs of overheating caused by damage or misuse, turn off power immediately.
Technical Information
Picture Part Specification
LED Light
(3 pieces)
Input: 9-15VDC, 5W, Female 5521
Output: Male 5521
CE, ROHS, IP44
In Line
on/off Dimmer
(1 piece)
Input: 9-15VDC, 2A, Female 5521, 30cm
Output: Male 5521, 30cm
Cable: 22#
Car Lighter Connector
(1 piece)
Input: Car Lighter Plug
Output: Male 5521
Cable: 22#, 2A, 5m
Mains Adaptor
(1 piece)
Input: 100-240VAC, 50Hz/60Hz
Output: 12VDC, 2A, Male 5521
Cable: 18#, 5m
Extension Cable
(2 piece)
Input: Female 5521
Output: Male 5521
Cable: 22#, 2A, 74cm
USB Extension Cable
(1 piece)
Input: USB Plug
Output: Male 5521
Cable: 22#, 2A, 3m
Remote
on/off - Dimmer
(1 piece)
Type: Infrared
Max Operating Distance: 3m
www.outdoor-revolution.com
Congratulations on your purchase of this Outdoor
Revolution, Lumi-Link LED lighting system.
We hope that this product adds to your outdoor
experience and enjoyment whilst using your
Outdoor Revolution Tent, Caravan Awning or
Driveaway Awning.
To ensure the correct use of this product and to promote
years of service and enjoyment, we would recommend
the following care and advice steps should be taken:
• Only ever use this product INSIDE your tent or awning.
• Only connect to the correct power source and only connect
using the power connection devices supplied in this kit.
• NEVER submerge any part of this product in water or attempt to
operate if you suspect water ingress into the lighting unit caused by
misuse or accidental damage.
• Wipe away any external condensated moisture with a dry cloth.
• Check all cables for any loose connections before attempting
to turn on the power.
• Always carefully pack the product away in its protective bag and
hard storage tube, taking care whilst folding cables and packing
into the storage lid compartment.
• Should you have any concerns or issues regarding the
operation of this product, please contact:
Outdoor Revolution Customer Service helpline:
