Outsunny 846-016 User manual

Assembly video please scan the QR code .
INbj027V02_UK

Warning: The storage compartment is not suitable
for depositing liquid gas cylinders！
02

•
Read the following instructions carefully and ensure that your barbecue is
correctly installed, assembled and maintained. Failure to follow these
instructions could cause serious injury and/or damage to property.
•Use outdoor only.
•Read the instructions before using the appliance.
•
WARNING : accessibile parts may be very hot . Keep young children away .
•This appliance must be kept away from flammable materials during use.
•Do not move the appliance during use.
•
Turn off the gas supply at the gas cylinder after use.
•Do not modify the appliance.
•Always use protective gloves when handling particularly hot components.
•For any question concerning the assembly or operation of the appliance,
please contact your retailer or LPG distributor.
•When choosing a site for use, always position the appliance and gas cylinder
on a flat surface.
•Never light the appliance with the LID closed.
•Your barbecue uses an 11 or 15 kg gas cylinder. Your barbecue's
performance will be improved by the use of propane or LPG mixtures. Butane
can be used but, due to the appliance's power, the cylinder will tend to seize
and produce low pressure gas, which will affect your barbecue's
performance.
•When choosing a location for your barbecue, the following criteria should be
taken into consideration.
•
Both sides and behind the barbecue: the sides and rear of the barbecue
should be 1 metre away from any item likely to impede its operation.
•Above the barbecue: THERE SHOULD BE NOTHING ABOVE THE BARBECUE.
•
The side burner only can be used with flat-bottomed pan with a diameter
between 16 cm and 22cm.
•
NOTE TO THE CONSUMER --- Please keep these instructions for future
reference.
03

04

05

06

c2
a1
08
09
07
c2
a1
a4
c
a
c
a
aa
a
a
07

Before start assemble part 14
must take away the protective plastic cap on the connector
08

12
13
⑦1
⑦
Correct position of side burner tube
09

15
14
16
g2
c2
c2
1
c2
1 1
1
g
c
c
c
c
c
After assemble side burner,
insert ignition wire into ignition pin
Adjust the pin point
at the burner hole.
3-5mm
10

11

12

Warning !!!
Identify any leaks after assemble & before use ! ( Refer to Leak Test Instruction, Page 15 )
Below connection are the parts which must test the leakage.
13

14

15

16

17
Trouble Shooting
Problem
Possible cause
Solution
Burners will not light
using the ignition
system
LP gas cylinder is empty.
Replace with full cylinder
Faulty regulator.
Have regulator checked or
replace
Obstructions in the burner
Clean burner
Obstructions in gas jet and hose
Clean jets and gas hose
Electrode wire loose or disconnected
on electrode or ignition unit
Reconnect wire
Electrode or wire is damaged
Change electrode and wire
Faulty push button igniter
Change igniter
Low flame
or flashback
(fire in burner tube-a
hissing or roaring noise
may be heard)
LP gas cylinder too small
Use larger cylinder
Obstructions in burner
Clean burner
Obstructions in gas jets or gas hose
Clean jets and gas hose
Windy conditions
Use BBQ in a more
sheltered position
Difficultly turning control
knob
Control Knob Broken
Replace control knob
Gas valve jammed
Replace gas valve