Outsunny 84C-247 Installation guide

ASSEMBLY & INSTRUCTION MANUAL
READ AND SAVE THIS INSTRUCTIONS FOR FUTURE USE
INbnc008_UK
84C-247

Warning: .
1. A 3 person assembly is required for this tent.
2. Please take appropriate actions as heavy rain, wind and snow
can damage the tent. If necessary please dis-assemble and store
for later use.
3. In snowy conditions please do not alow the thickness of the
snow to be more than 5cm on the roof, this should be cleared as
soon as possible for your safety.

PART
LIST
01
1. Place the frame in the center of the desired location. Stand opposite a partner and lift
frame off the ground walking backwards away from partner.
① 1 ② 1
③ 1 ④ 8

03
02
3. Open frame completely and engage the slider at each corner by placing one hand on the truss, one
hand on the top of the leg and pushing up until the pin “clicks” in place.
2. Place canopy top over partially opened frame. Align eve extension corners of the top and
the frame then attach the elastic loops to each corner of the frame.

05
04
5. Extend each inner leg to raise canopy to the desired height by stepping on the lower
footpad and allowing the snap button to lock in place. Adjust to desired height with the 3
height levels.
4. Attach the hook and loop straps to each corner and overhead truss bars.

7. Secure the gazebo by driving a stake down through one of the holes in each foot base.
6. Attach corner to top truss bars.
07
06

1. Put up all stakes from ground.
After Each Use
Done
01
Disassembling the Gazebo
Store all parts (like the stakes) in the corresponding bag tofabric.

3. Raise a leg off the ground and depress the snap button to disengage the lower leg. Repeat until all
four legs have been lowered.
2. Detach hook and loop straps from the top.
03
02

5. Remove elastic loops on the top from each eve extension corner. Stand opposite a partner and
grasp the lower truss bar. Lift the frame off the ground and slowly walk toward partner being careful
not to pinch fingers.
4. Pull the pin on the slider at each corner bracket to disengage the frame and allow it to
close.
05
04

7. Store frame and top in roller bag.
6. Remove canopy top and completely close frame. Recommends storing canopies without
the top to avoid mildew and pinch tears.
07
06
Done