Outwater Fulterer OI-771 User manual

1.800.631.8375 | www.outwater.com
Date: 10.17.2013
Revision: 1.2
Article Number: 7100099
MOUNTING INSTRUCTIONS
OI-771: Progressive-Action Pantry Pull-Out, Bottom Mount
275 lbs. Capacity with Matching Top Guide

Outwater Industries, Inc. assumes no liability for improper installation. Page 2

Outwater Industries, Inc. assumes no liability for improper installation. Page 3
MOUNTING
MOUNTING
+The Top Guide mounts as shown in
drawing 1 and the hole location drawing
on page 4 using #6 at head screws.
+OI-771 Progressive-Action Pantry-Pull-out
Drawer slide mounts in cabinet as shown in
drawing 2 and according to the hole
location drawing on page 4 using #10
at head screws and M6/¼-20 bolts.

Outwater Industries, Inc. assumes no liability for improper installation. Page 4
HOLE LOCATIONS

Outwater Industries, Inc. assumes no liability for improper installation. Page 5
+The U-Prole of the Top Guide mounts
as shown in drawing 3, 1a and the
hole location drawing on page 4 using
#6 at head screws.
+The lower adapter mounts as shown in
drawing 4, 2a and the hole location
drawing on page 4 using #6 at
head screws.

Outwater Industries, Inc. assumes no liability for improper installation. Page 6
+Insert the pull-out as shown in drawing 5a/b
and 6a/b and push it to the end stop.
While sliding-in, the stop piece at the top
snaps in the three times and it should “Click”
three times (Fig. A). The adapter at the bottom
should click into the black hooks on the slide.
+Close Allen screws carefully to secure the
adapter (Fig. C).
+Use the Allen screws in the bottom slide as
shown in drawing 7 for the lateral adjustment
of the pull-out (Fig. C).
+Use the slotted holes in the U-prole of the
top guide to make the upper lateral
adjustment of the pull-out as shown in
drawing 8 and Figure B.

Outwater Industries, Inc. assumes no liability for improper installation. Page 7
+Loosen the lateral adjustment screws prior to
making tilt adjustment. Tighten lateral
adjustment screws to lock guide in place when
nished.
+NOTE: Tighten screws rmly.
+The stop piece at the Top Guide as shown in
drawing 9 has to be adjusted to the load by
snapping in the proper position (Fig. E).
There are 4 position possibilities.
+The top slide has to stay extended while
pushing the pull-out 20mm in (the part where
the arrow “a” is pointing). If the slide closes,
pull the slide open before attempting
adjustment.

Outwater Industries, Inc. assumes no liability for improper installation. Page 8
+Adjust the catch of the easy close with the
loaded pull-out as show in drawing 10 and
Figure F. The black catch block must be set
1mm over the latch/ECD housing as shown
using an Allen wrench.
+NOTE: Do not lubricate any part of the OI-771.
+While extended, loosen the lateral and the tilt
adjustment screws (Fig. C+D).
+Close the pull-out approximately 20mm (3/4”).
The top guide slide should be fully open. If it is
not, it will be dicult to push down the stop in the
next step.
+Push the stop piece down and push the top guide
slide completely in to clear the adapter (Fig. G).
Pull the pull out forward and up to release from
the black hooks as shown in drawing 11.
DISASSEMBLY