overstock 263 User manual

ITEM
NO.
:
263
REVISED JUL 2, 2012
Printed in Vietnam
- 1 -
Description
Item No.
:
MISSION JUVENILE CHAIR
: 263
ASSEMBLY
INSTRUCTIONS

ITEM
NO.
:
263
REVISED JUL 2, 2012
Printed in Vietnam
- 2 -
BEFORE ASSEM
B
LY
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning
assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is
missing or defective, please contact the store where purchased. If hardware is missing, or you need help with
assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
PART
LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO Description Qty Sketch NO Description Qty Sketch
A Chair back 1 B Front frame 1
C Side Apron
(L-R) 2
D Seat 1
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM
NO.
:
263
REVISED JUL 2, 2012
Printed in Vietnam
- 3 -
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO Description Qty Sketch NO Description Qty Sketch
1
Short bolt
(M6x40mm)
4 2
Long bolt
(M6x50mm)
2
3
Screw
(M4x30mm)
3 4
Flat Washer
(ɸ6.5x14mm)
4
5
Lock Washer
(ɸ6.5x11mm)
4 6
Curve Washer
(12x16mm)
2
7
Allen Key
(4mm)
1
STEP 1
Attach Side Aprons (C) to the Back (A) with Short bolts (1), and Washers (4) and (5). Tighten with the
Allen Key (7)
Note: DO NOT fully tighten any of the bolts, until the chair is assembled, then put on a flat level
surface to make sure the chair is level and then tighten the bolts.

ITEM
NO.
:
263
REVISED JUL 2, 2012
Printed in Vietnam
- 4 -
STEP 2
Attach Front frame (B) to Side Aprons (from Step 1) with bolts (2) and Curve Washers (6). Tighten with
the Allen Key (7)
STEP 3
Attach the Seat (D) to top of the seat frame (from Step 2) by using Screws (3). Tighten with a screw
driver.