overstock T-30RT User manual

ITEM : T-30RT AND T-30P ( PACKED IN SEPARATE BOX )
REVISED JUN 16, 2014 Printed in Vietnam
- 1 -
ASSEMBLY INSTRUCTIONS
_________________________________________________________________________________
Description
Item No.
: ROUND TABLE TOP
: T-30RT AND T-30P
( PACKED IN SEPARATE BOX )

ITEM : T-30RT AND T-30P ( PACKED IN SEPARATE BOX )
REVISED JUN 16, 2014 Printed in Vietnam
- 2 -
BEFORE ASSEMB
LY
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning
assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is
missing or defective, please contact the store where purchased. If hardware is missing, or you need help with
assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
PART
LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please
make sure you have the following parts:
NO Description Qty Sketch NO Description Qty Sketch
A Top 1 B Mounting
Plate 1
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please
make sure you have all of the following hardware:
NO Description Qty Sketch NO Description Qty Sketch
1 Bolt
(M6x35mm) 8
2 Flat washer
(6.5x13mm) 4
3 Flat washer
(6.5x19mm) 4
4 Lock washer
(6.5x11mm) 8
5 Allen key
(4X80mm) 1

ITEM : T-30RT AND T-30P ( PACKED IN SEPARATE BOX )
REVISED JUN 16, 2014 Printed in Vietnam
- 3 -
STEP 1
Attach the mounting plate (B) to the pedestal (D), with bolts (1), washers (2) and (4) as shown below.
Tighten with Allen key (5).
STEP
2
Carefully put the pedestal block on the bottom side of the table top, attach the top (A) to mounting
plate (B) with bolts (1), washers (3) and (4) as shown below. Tighten with Allen key (5).