Owon SAC451 User manual

SAC451 Smart Access Control
Quick Start Guide

2
Welcome
1
The Smart Access Control SAC451 is used to control the electrical doors
in your home. You can simply insert the Smart Access Control into the
existing and use the cable to integrate it with your existing switch. This
easy-to-install smart device allows you to control your lights remotely.
This guide will provide you with an overview of the product and help you
get through the initial setup to installation.

3
2Get to know your device
Reset button
LED indicator
Reset Button
• Bind mode. Press and hold the Reset button for about three seconds
until the LED indicator flashes three times to enter bind mode.
• Reset. Press and hold the Reset button for ten seconds until the LED
indicator flashes three times to reset the Smart Access Control to default
factory setting, the LED indicator will keep flashing after the device is
successfully reset.

4
LED status What it means
LED keep ashing
(0.5s On, 2s O) Device has not joined a network.
Flashing three times
(0.1s On/O)
Intuitive End Device Bind or Return
to Factory Settings.
Green LED solid Device has joined a network.
LED indicator
The LED status gives the following information of the Smart Access
Control:

5
Get started
3
3.1 To get started, you will need:
A ZigBee gateway.
A pin.
3.2 Installation
Please refer to the installation diagram below to install the Smart Access
Control.

6
6-24V DC IN
Connection box
Installation diagram
Note: output is pulse singal,
width 2s.

7
3.3 Connect to the gateway's network
1. Install the Smart Access Control and the LED indicator will start flashing
(reset the Smart Access Control if not).
2. Set your ZigBee gateway to permit joining and the Smart Access Control
will join the gateway's network automatically, the LED indicator will
become steady when successfully joined.
3. Check your mobile App, and you will be able to see the Smart Access
Control under “Automation” interface. If it has not, reset the Smart Access
Control and repeat step 2.
Note: You could also use the wireless switch and the remote control to
control your Smart Access Control. To do so, simply refer to the user guide
of the specific device.

8
4Technical Specications
Wireless Connectivity • ZigBee 2.4GHz IEEE
RF Characteristics
• Operating frequency: 2.4GHz
• Internal PCB Antenna
• Range outdoor/indoor: 100m/30m
ZigBee Profile • Home Automation Profile
Operating Voltage • DC 6-24V
Operating Current • 30mA @ 12V
Max Current • 70mA @ 12V
Dimensions • 55.3(L) x 39(W) x 17.7(H) mm
Weight • 42g

9
Safety Handling
WARNING: Failure to follow these safety notices could result in fire,
electric shock, other injuries, or damage to the Smart Access Control
and other property. Read all the safety notices below before using the
Smart Access Control.
5
• Avoid high humidity or extreme temperatures.
• Avoid long exposure to direct sunlight or strong ultraviolet
light.
• Do not drop or expose the unit to intense vibration.
• Do not disassemble or try to repair the unit on your own.
• Do not expose the unit or its accessories to flammable
liquids, gases or other explosives.