Oxford Garden Oxford User manual

15 Kingbrook Parkway, Suite 100 Simpsonville, KY 40067 p. 877.866.3331 f. 502.719.8888 oxfordgarden.com
Ver. 06.30.20
48” ROUND DINING TABLE
ASSEMBLY INSTRUCTIONS
COMPONENTS
HARDWARE
FINISHING ITEMS
Medium Grit Sandpaper
If the furniture is going to be placed on a concrete or tile patio, it should first be rinsed well to remove
the sawdust that may cause some staining.
Table Top Assembly
Quantity: 1
Corner Posts
Quantity: 4
2
Pedestal Base
Quantity: 1
Parasol Hole Cap
Quantity: 1
34
A
Metal Washers
Quantity: 8
B
Hex Nuts
Quantity: 8
C
Machine Bolts
Quantity: 5
Barrel Nuts
Quantity: 4
D
Allen Wrench
Quantity: 2
E
Hex Head Wrench
Quantity: 1
F

Ver. 06.30.20
How to align barrel nuts and bolts
Insert a guiding bolt into the end of a
barrel nut
Align the barrel nut inside of the compo-
nent with the bolt used to connect the
components
Once the component bolt is aligned and
threaded, simply pull the guiding bolt
from the end of the barrel nut.
STEP 2
Secure corner post to the table top using two of the
metal washers and two of the Hex Nuts with the Hex
Wrench provided. Repeat Steps 1-2 for the remaining
corner posts.
INSTRUCTIONS
STEP 1
Lay table top upside down on a clean, flat surface.
Insert the threaded rods on one corner post into holes
located on one corner of table top.
Ver. 2019.06.03
STEP 3
Position pedestal base onto legs as shown. Insert one
barrel nut into hole on the side of a leg. Align the barrel
nut to receive the machine bolt through the pedestal
base and into the leg.
STEP 4
Tighten Bolt with allen wrench and repeat for
remaining legs.
STEP 5
Turn upright and enjoy!

2

2
AB
D
C
3
C
C
C
C
3
D
D
D
D