OYPLA Home 3680 User manual

USER MANUAL Model No: 3680/3681/3682
User Manual
Oil Filled Radiator

Safety Instructions
USER MANUAL Model No: 3680/3681/3682
Please read the entire instruction manual before using the product and then save it for future reference. We reserve the right for
any errors in text or images and any necessary changes made to technical data. In the event of technical problems or other
queries, please contact our Customer Services.
•The product should only be connected to a 220-240V AC, 50Hz
electrical outlet.
•Never leave the product unattended whilst it is switched on.
•If you have to leave the product unattended, even for a short
while, always switch it off.
•Keep the product out of children’s reach and do not allow children
to use it.
•The product is only intended for normal domestic use and only in
the manner described in this instruction manual.
•Inspect the mains lead regularly. Never use the product if the
mains lead or plug has been damaged in any way.
•Do not place the mains lead on or near any hot surface.
•Do not touch the product if your hands are moist or wet.
•Never move the product by pulling on the lead.
•Keep furniture, curtains and other flammable material at least 1
metre away from the product.
•Do not run the power cord under carpets, rugs etc. or anywhere
where is may present a trip hazard.
•Do not use this heater in bathrooms.
•Never place the cable directly against the heater or close to a hot
air outlet.
•Do not touch the heater the heater during use as it will get very
hot and could cause injury.
•The heater must not be located immediately below or next to a
mains power supply.
•Never cover the heater in any way.
•Do not move the heater whilst it is use.
•Never use the heater in areas where explosive gasses or liquids
are stored.
•The heater should be used on a stable, heat-resistant surface.
•This product is not intended for use by persons (including
children) with reduces physical, mental and sensory capacities, or
lack of experience and knowledge, unless they have been given
supervision or instructions concerning the use of the product by
persons responsible for their safety.
•Do no discard of any packaging until you have checked that you
have all of the parts and fittings required.
•If the product is damaged or has any defects, please contact
[email protected]

Operating Instructions
USER MANUAL Model No: 3680/3681/3682
Product Details
1. Carry handle
2. Adjustable thermostat
3. Heat indicator light
4. Low heat switch
(600W 7-fin model)
(800W 9-fin model)
(1000W 11-fin model)
5. Medium heat switch
(900W 7-fin model)
(1200W 9-fin model)
(1500W 11-fin model)
6. Cord storage
7. Castors
8. Oil filled fins
9. Wheel base assemblies
10. U-shaped bolt(s)
11. Castor fixings
1
9
7
10
8
6
4
3
11
5
2

Operating Instructions
USER MANUAL Model No: 3680/3681/3682
Installation
Install the wheel base assemblies onto the bottom of the radiator by
carefully turning it upside down. Position the wheel base assemblies
onto the bottom, below the two fins on either end of the radiator.
Fix the wheel base assemblies into position using the U-shaped
bolts and win nuts.
Secure the castors onto the ends of the wheel base assemblies
using the fixings provided. The castors should be securely fixed so
that only the wheels are able to move.
Note: When using the radiator for the first time, a slight odour may
be emitted. This is normal and will soon subside. Ensure there is
sufficient ventilation around the radiator.
Operating Instructions
1. Plug the heater into a 220-240V AC outlet. The heater will be
on standby mode.
2. Turn the heater on by pressing any of the heat setting
switches.
3. For a low heat setting, press the left switch. For a medium
heat setting, press the right switch. For a high heat setting,
press both of the switches.
4. The adjustable thermostat can be used to finely regulate the
temperature. Turn it in a clockwise direction to increase the
heat output. To reduce it, turn in an anticlockwise direction.
5. Turn off the radiator by pressing any active heat switches.
Warning: The radiator contains oil, which will cool down slowly
after the mains power supply has been disconnected. Allow the
radiator to full cool before moving and also use the built-in carry
handle.
Overheat Protection
The heater has been provided with an overheating safety sensor that turns the
heater off if there is a technical malfunction or if it is being used incorrectly
(such as obstruction of the air vents). If it happens, you must unplug the heater
and remove the cause of overheating or correct the malfunction.
After a cooling down period of approximately 15 minutes turn the heater back
on.
Care and Maintenance
•Before cleaning the heater, disconnect the plug from the power supply
and allow it to cool down fully.
•Clean the casing with a damp cloth. Do not use any strong or abrasive
cleaning materials and do not allow water to reach any internal parts.
•Do not immerse the radiator in water or any other lquid
Disposal of Unit
Products bearing the symbol shown above means that
used electrical and electronic equipment (WEEE) should
not be mixed with general household waste. For proper
treatment, recovery and recycling, please take this
product(s) to designated collection points where it will be
accepted free of charge. Disposing of this product
correctly will help save valuable resources and prevent
any potential negative effects on human health and the
environment, which could otherwise arise from
inappropriate waste handling. Please contact your local
authority for further details of your nearest designated
collection point. Penalties may be applicable for incorrect
disposal of this waste, in accordance with your national
legislation.
Imported into EU by Oypla.com LLP, Uxbridge, UB8 2FX