OYPLA Home 4597 User manual

Page 1
Model Code: 4597
Oypla.com LLP / www.oypla.com
User Manual
Model Code: 4597
Contents
1Front Cover
-
2Safety
Instructions
-
3Operating
Instructions
-
3Cleaning &
Maintenance
-
4Assembly
Instructions
-
4Back Cover
End
450W Convector
Heater

Page 2
Model Code: 4597
Oypla.com LLP / www.oypla.com
Contents
1Front Cover
-
2Safety
Instructions
-
3Operating
Instructions
-
3Cleaning &
Maintenance
-
4Assembly
Instructions
-
4Back Cover
End
Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold
on this condition, which no representative of the company can waive or change.
The product should only be connected to
a 220-240V AC, 50Hz electrical outlet.
Never leave the product unattended
whilst it is switched on.
If you have to leave the product
unattended, even for a short while,
always switch it off.
Keep the product out of children’s reach
and do not allow children to use it.
The product is only intended for normal
domestic use and only in the manner
described in this instruction manual.
Inspect the mains lead regularly. Never
use the product if the mains lead or plug
has been damaged in any way.
Do not place the mains lead on or near
any hot surface.
Do not touch the product if your hands
are moist or wet.
Never move the product by pulling on
the lead.
Keep furniture, curtains and other
flammable material at least 1 metre
away from the product.
Do no discard of any packaging until you
have checked that you have all of the
parts and fittings required.
Do not run the power cord under
carpets, rugs etc. or anywhere where is
may present a trip hazard.
Do not use this heater in bathrooms.
Never place the cable directly against the
heater or close to a hot air outlet.
Do not touch the heater the heater
during use as it will get very hot and
could cause injury.
The heater must not be located
immediately below or next to a mains
power supply.
Never cover the heater in any way.
Do not move the heater whilst it is use.
Never use the heater in areas where
explosive gasses or liquids are stored.
This product is not intended for use by
persons (including children) with reduces
physical, mental and sensory capacities,
or lack of experience and knowledge,
unless they have been given supervision
or instructions concerning the use of the
product by persons responsible for their
safety.
If the product is damaged or has any
defects, please contact
[email protected]
Warnings

Page 3
Model Code: 4597
Oypla.com LLP / www.oypla.com
Contents
1Front Cover
-
2Safety
Instructions
-
3Operating
Instructions
-
3Cleaning &
Maintenance
-
4Assembly
Instructions
-
4Back Cover
End
Operating Instructions
Please refer to the diagram below for instructions on how to operate your product.
1. Turn the rotary knob (5) clockwise as far as it will go.
2. Wait until the heater has warmed up the room to the desired temperature,
and then turn the knob back slowly until the control lamp (4) goes out.
3. The thermostat is now set at the current temperature and will turn ON
when the temperature drops below this point, or OFF when above.
Cleaning & Maintenance
Please refer to the instructions below in regards to cleaning and maintaining your product.
Before cleaning the heater, disconnect the plug from the power supply and
allow it to cool down fully.
Clean the casing with a damp cloth. Do not use any strong or abrasive
cleaning materials and do not allow water to reach any internal parts.
Do not immerse the heater in water or any other liquid.

Page 4
Model Code: 4597
Oypla.com LLP / www.oypla.com
Contents
1Front Cover
-
2Safety
Instructions
-
3Operating
Instructions
-
3Cleaning &
Maintenance
-
4Assembly
Instructions
-
4Back Cover
End
Assembly Instructions
Before use, the feet should be
attached using the four screws
provided, as shown in the
diagram to the left.