OYPLA Home 3940 User manual

80w Tubular Heater
USER MANUAL Model No: 3940
User Manual

Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold on
this condition, which no representative of the company can waive or change.
•It is important that the Tubular Heater is mounted horizontally to a wall at low-level.
•Do not mount below a socket outlet.
•Any shelving placed above the Tubular Heater must be at a distance of at least 20cm.
•Air should be allowed to freely circulate around the Tubular Heater to avoid
overheating.
•The surface of the Tubular Heater can get very warm; in order to avoid overheating,
do not cover.
•Children or elderly individuals should not be left unsupervised in the vicinity of the
heater.
•Precautions should be taken to ensure that direct contact with the heater cannot
occur.
•This product is not a toy, and should only be used for its designated purpose.
•Wiping over with a damp cloth and finishing with a soft dry cloth can maintain the
finish of your Tubular Heater. This should be carried out when the tube is cold and
switched off.
•Do not use abrasive cleaning powders or metal polish on any part of the tube.
•The Tubular Heater is suitable for operation for a 230V BS Plug as shown on the
identity level.
•If the product is damaged or has any defects, please contact cs[email protected]
USER MANUAL Model No: 3940

Operating Instructions
Parts List:
If you are missing any of the below parts please contact [email protected]om
Please be aware that you will be referring to this parts list throughout the assembly process.
USER MANUAL Model No: 3940
1. The fixing bracket should be mounted according to the heater length at a distance
to adequately support the Tubular Heater.
2. Screw the two bottom halves of the bracket to the wall, place Tubular Heater on
brackets and then fasten top brackets over tub.
3. Before connecting the heater check that the supply voltage is the same as that stat
eon the identify label.
Assembly Instructions
Please retain a copy of all instructions for future consultation.