OYPLA Home 3940 User manual

Page 1
Manual Version: v1.0
Model Code: 3940
Oypla.com LLP / www.oypla.com
User Manual
Model Code: 3940
Contents
1Front Cover
-
2Safety
Instructions
-
3Assembly
Instructions
-
3Back Cover
End
120w Tube Heater

Page 2
Manual Version: v1.0
Model Code: 3940
Oypla.com LLP / www.oypla.com
Before cleaning, ensure the heater is
cool, and switched off at the mains
outlet.
Contents
1Front Cover
-
2Safety
Instructions
-
3Assembly
Instructions
-
7Back Cover
End
Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold
on this condition, which no representative of the company can waive or change.
•This product is not a toy, and is only to
be used for its designated purpose.
•Do not make alterations or modifications
to this product.
•Precautions should be taken to ensure
that direct contact with the heater
cannot occur.
•The surface of the heater can become
hot during operation. To prevent
overheating, do not cover.
•Air should be allowed to freely circulate
around the heater, to avoid it
overheating.
•Clean only using a damp cloth. Do not
use strong industrial cleaning
substances, as these may damage the
product.
•The tubular heater is suitable for
operation for a 230V BS Plug as shown
on the identity level.
•Any shelving placed above the heater
must be at a distance of at least 20cm.
•If your product is damaged or has any
defects, please contact
[email protected]
Warnings
Do not touch the heater whilst it is in
operation.
Never cover the tubular heater.
Do not use abrasive cleaning
powders or metal polish on any part
of the tube.
Do not allow the heater to operate for
extensive periods of time. Always keep
the heater supervised.

Page 3
Manual Version: v1.0
Model Code: 3940
Oypla.com LLP / www.oypla.com
Parts List:
If you are missing any of the below parts, please contact [e-mail]
Please be aware that you will be referring to this parts list throughout the assembly process.
The fixing bracket should be mounted according to the heater
length, at a distance to adequately support the tubular heater.
Screw the two bottom halves of the bracket to the wall, place
the tubular heater on brackets, and then fasten top brackets
over the tub.
Before connecting the heater, check that the supply voltage is
the same as that is stated on the rating label.
Contents
1Front Cover
-
2Safety
Instructions
-
3Assembly
Instructions
-
3Back Cover
End
Assembly Instructions
1
2
3
Environmental Protection
Products bearing the symbol shown below means that used electrical and electronic equipment (WEEE) should not be
mixed with general household waste. For proper treatment, recovery and recycling, please take this product(s) to
designated collection points where it will be accepted free of charge. Disposing of this product correctly will help save
valuable resources and prevent any potential negative effects on human health and the environment, which could
otherwise arise from inappropriate waste handling. Please contact your local authority for further details of your
nearest designated collection point. Penalties may be applicable for incorrect disposal of this waste, in accordance with
your national legislation.