OYPLA Home 3680 User manual

User Manual
USER MANUAL Model No: 3680, 3681, 3682, 3853
Oil Filled Radiator
*SIZE/NUMBER OF FINS MAY VARY*

•This product is not a toy, and is only to be used for its designated purpose.
•Never carry out any alterations or modifications to this product.
•This product is intended for indoor use only.
•When the appliance is not in use, always unplug from the mains socket.
•Only use this product on stable, level and dry ground. Be sure that the surface on which the
heater is placed is also heat resistant.
•The product should only be operated by an adult and kept away from immediate contact with
children. Some parts of this product can become very hot and cause burns. Particular attention
has to be given where children and vulnerable people are present.
•The heater must not be located immediately above or below a power socket.
•Do not use the heater near sources of water (such as a bath or shower).
•The heater is filled with a specific quantity of special oil. Repairs requiring the opening of the
oil container are to be made by the manufacturer, who should be contacted if there is an oil
leak.
•When first using the product an odour may begin to develop. This is normal and will disappear.
•Do not allow foreign objects to enter the ventilation or exhaust openings as this may cause an
electric shock, fire or damage to the appliance.
•This heater should be used in an earthed wall socket, but if an extension cord is needed then
please ensure that you do not exceed
•This product is not intended for use by persons (including children) with reduced physical,
sensory or mental capacities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the product by persons responsible for their
safety.
•Clean only with a damp cloth. Do not use strong industrial cleaning substances or abrasive
materials as these will damage the product. Make sure the product is off, unplugged from the
socket and been left for five minutes to remove the risk of electrical shock.
•If the product is damaged or has any defects, please contact [email protected]
Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold
on this condition, which no representative of the company can waive or change.
USER MANUAL Model No: 3680, 3681, 3682, 3853

USER MANUAL Model No: 3680, 3681, 3682, 3853
Operating Instructions
Parts List:
If you are missing any of the below parts please contact [e-mail]
Please be aware that you will be referring to this parts list throughout the assembly
process.
1. Turn the
heater upside
down.
2. Position the
wheel base
between the end
fins.
3. Attach the
wheel base to the
heater using the
U-bolts and wing
nuts supplier.
4. Tighten the
wing nuts.
5. Turn the
heater the
right way up.
WARNING:
Only operate the radiator in the normal
upright position with the wheels attached to
the bottom. Any other position could create a
hazardous situation. If you are concerned
when it comes to installing the product,
please consult a qualified electrician.
Parts:
A. Oil filled fins
B. Moving handle
C. Indication light
D. Temperature control
E. Power switch
F. Cord storage
G. Wheel base
H. Wheels
•Read all the instructions provided before using the heater.
•Never allow children to operate or play with the heater.
•Never clean the heater parts with any flammable materials. The fumes can create a fire hazard
or explosion.
•
Do not store the product in the vicinity of gasoline or any other flammable vapours and liquids.
The fumes can create a fire hazard or explosion.
•UNPLUG OR DISCONNECT THIS HEATER FROM THE POWER SOCKET BEFORE SERVICING.
To reduce the risk of fire, electric shock or injury
to persons or property, please follow these basic
precautions when using the heater.

Imported into the EU by Oypla.com LLP, Uxbridge, UB8 2FX
Environmental Protection
Products bearing the symbol shown above means that used electrical and electronic equipment (WEEE) should not be mixed with general
household waste. For proper treatment, recovery and recycling, please take this product(s) to designated collection points where it will be
accepted free of charge. Disposing of this product correctly will help save valuable resources and prevent any potential negative effects on
human health and the environment, which could otherwise arise from inappropriate waste handling. Please contact your local authority for
further details of your nearest designated collection point. Penalties may be applicable for incorrect disposal of this waste, in accordance with
your national legislation.
Please retain a copy of all instructions for future
consultation.
USER MANUAL Model No: 3680, 3681, 3682, 3853
Cleaning your Heater
1. Always disconnect the heater from the power
supply before beginning to clean.
2. Clean the outside of the heater by wiping with a
damp cloth and buff with a dry cloth.
3. DO NOT attempt to use any waxes or polishes as
these may cause discoloration.
Storing your Heater
1. Save the box for the off season storage,
2. Clean the heater following the cleaning
instructions above.
3. Remove the wheel base assemblies.
4. Place the heater and the wheel parts back into
the original box and store in a cool and dry place.
5. If you wish to store the heater fully assembled,
be sure to cover it to protect it from dust.
Operation
1. Before turning on, ensure the heater is plugged
into the socket, the power is switched to “0”and
the thermostat is at the minimum setting.
2. Turn the power switch to “●” for minimal
output, to “●●” for medium output, or “●●●” for
maximum output.
Turn the thermostat knob clockwise the
maximum position.
3. Once the room temperature is at a comfortable
level, slowly turn the thermostat anti-clockwise
until the indicator light hoes out. The heater will
then attempt to keep the room temperature at
the desired level.
4. Do not cover the heater at any time during
operation. There is a risk of fire if the heater is
covered.
5. Once you have finished using the heater ensure
that you turn the power switches off, and the
thermostat control switch to the “0” positions.
Then unplug from the mains supply.

Model identifier(s): 3680, 3681, 3682, 3853
Item
Symbol
Value
Unit
Item
Unit
Heat output
Type of heat input, for electric storage local
space heaters only (select one)
Nominal heat output
Pnom
2.5
kW
manual heat charge control, with
integrated thermostat
No
Minimum heat output
(indicative)
Pmin
1.0
kW
manual heat charge control with
room and/or outdoor temperature
feedback
No
Maximum continuous heat
output
Pmax,c
2.5
kW
electronic heat charge control with
room and/or outdoor temperature
feedback
No
Auxiliary electricity
consumption
fan assisted heat output
No
At nominal heat output
elmax
N/A
kW
Type of heat output/room temperature control
(select one)
At minimum heat output
elmin
N/A
kW
single stage heat output and no
room temperature control
No
In standby mode
elSB
0
kW
Two or more manual stages, no
room temperature control
No
with mechanic thermostat room
temperature control
Yes
with electronic room temperature
control
No
electronic room temperature
control plus day timer
No
electronic room temperature
control plus week timer
No
Other control options (multiple selections
possible)
room temperature control, with
presence detection
No
room temperature control, with
open window detection
No
with distance control option
No
with adaptive start control
No
with working time limitation
No
with black bulb sensor
No
Contact details
Oypla.com LLP, Uxbridge, UB8 2FX