Cleaning and Care
1. Before you begin to clean the product, make sure
that the product is off and is unplugged from the
socket.
2. Take the lid off of the vacuum cleaner by
unclipping the clips on the side of the lid. When
removing the lid, be sure to not drop of throw the lid
to the side as the filtration system is built into the lid
and doing so will cause damage to the system.
3. Remove the filtration bag, ensuring that all items
brought in by the input tube are in the bag. Empty
the filtration bag into the correct bin. Wash the
inside of the vacuum cleaner. Put the filtration back
inside the vacuum cleaner. Do not throw the
filtration bag away.
4. If you have used an extender pipe and one of the
attachments, simply wash out the extender pipe
with arm, soapy water and leave to dry. With the
pipe attachments, run them under warm water and
dry manually.
5. Before plugging the product back in, make sure all
areas around the electrical components are dry to
avoid injury and product damage.
Before First Use
•Remove the lid and take all the parts out from
inside the vacuum cleaner. Be sure to check that you
have all the parts.
•Attach the filtration back to the highest hole in the
vacuum cleaner.
•Be sure to check the labels on the plug and ensure
the volts correlate to the volts from the wall socket.
How to Use
1. Place the input tube inset the top hole in the
vacuum cleaner, then place it into the water source.
2. Place the output tube into the opposite hole in the
vacuum cleaner, then place it in the same water
source.
3. Press the ‘ON/OFF’ switch into the ‘ON’ position.
This will cause the water to begin to be sucked into
the vacuum cleaner. Allow the vacuum cleaner to
work. It will suck water in then automatically filter
out the clean water (removed of items such as
stones and wood). Allow this to continue until the
filtration bag is fully or you have cleaned the pond.
4. Once finished, remove both tubes from the
vacuum cleaner and empty the filtration bag. Place
all items into the vacuum cleaner and then store.
Use as a Dry Vacuum Cleaner
ATTENTION: Only use the unit as a dry vacuum cleaner
with the enclosed filter bag!
1. Ensure the unit stands safely.
2. Switch the unit off with the switch and pull the power
plug.
3. Unlock the container locking system and remove the
motor housing.
4. Pull the enclose filter bag over the suction socket
inside the container.
5. Refit and lock the motor housing. Connect the unit to
the power supply and turn it on with the switch.
Select a suitable nozzle.
6. Once you are finished with the product, turn the unit
off at the switch.
USER MANUAL Model No: 3089
Wearing Parts
Foam filters, valve rubber parts and filter bags are
wearing parts and are, therefore, not covered by our
warranty.
Storage
Empty out the collection container and clean the
unit. Store in a dry, frost protected room,
inaccessible to children.
