What’s in the Pack. . .
P3Solar • 4500 E. Speedway Blvd. Suite 50 Tucson, AZ 85712 USA • 520-775-1390 • sales@p3solar.com • www.p3solar.com
Carry/Storage
Bag
Step 1 & 2: First, remove all the contents from the EZ-Out Solar System bag. Expand collapsible frame by
moving the center struts toward each other until you hear the snap buttons click into the side’s holes.
EZ-Out Solar Charger Quick Start Guide
EZ-Out Tent
Pole
EZ-Out Collapsible
Frame
EZ-Out Solar
Panel
EZ-Out Frame
Stakes 8 ft SAE
Extension Cable
EZ-Out Packing
Tube
How to set up the EZ-Out Frame
Remove all contents from the bag Open the frame by moving the
center struts toward each other
Stake the center strap forward
Stake the two front legs Stake the two back straps
Step 3: Using a hammer, secure frame to ground with the 5 ground stakes provided. Center strap is staked forward to provide panel support.
How to set up the Rollable Panel
Hook solar panel Velcro to frame Unroll solar panel and hook to
Velcro on other side of the frame
Step 4: Hook panel’s exposed Velcro ap to frame. Unroll solar panel and secure other side
Velcro ap over opposite frame corner.
Insert tent pole into the pocket on
one end of the solar panel
Insert tent pole into the pocket
on the other end of the solar
panel Step 6: There are four cinch straps located on
the solar panel, two on each side. One side,
loop the cinch straps behind frame struts and
wrap around ring. Pull panel to frame edge
and secure Velcro cinch. Perform the same
on the other side and frame leg.
Insert tent pole into the pocket on
the other end of the solar panel
Step 5: Connect collapsed poles to form one piece. Insert one end of the tent pole into the
pocket on one of the bottom ends of the solar panel. Insert the other end of the tent pole into the
pocket on the opposite side of the bottom end of the solar panel. Maneuver the tent pole so it
slides behind the solar panel securing the lower half.
