Pablo LIM360 Programming manual

TIGHTEN SET SCREW WITH PROVIDED HEX KEY
TO PREVENT REMOVAL OF ARM FROM BASE

4
4
SWITCH CONTROL
TAP OPTICAL SWITCH BRIEFLY TO CYCLE THROUGH HIGH, LOW AND OFF. PRESS AND HOLD OPTICAL SWITCH TO ACTIVATE
FULL RANGE DIM CONTROL. RELEASE FINGER FROM OPTICAL SWITCH WHEN DESIRED LIGHT LEVEL IS REACHED.
USB SPECIFICATIONS
SINGLE 5.0V USB OUTPUT SUPPORTS CHARGING FOR SMARTPHONES, TABLETS AND OTHER MOBILE DEVICES.
USB 2.0 OR 1.1 STANDARD CORD REQUIRED (CORD NOT INCLUDED)
OUTPUT VOLTAGE: 5VDC + - 5%
OUTPUT CURRENT: 1A MAX
NOTE
LIM360 WILL CONTINUE TO CHARGE YOUR MOBILE DEVICE EVEN WHEN LAMP IS IN THE “OFF” POSITION.
PLEASE REFER TO YOUR MOBILE DEVICE’S USER MANUAL FOR COMPATIBILITY AND CHARGING TIME. PLEASE REFRAIN
FROM LEAVING YOUR DEVICE PLUGGED IN FOR LONGER THAN THE RECOMMENDED TIME, OTHERWISE IT MAY
RESULT IN OVER CHARGING.
PRESS AND HOLD SWITCH FOR 2.5 SECONDS TO TURN OFF. PRESS BRIEFLY TO CYCLE THROUGH THREE STAGES.
CARE INSTRUCTIONS
WIPE CLEAN WITH A SOFT DAMP CLOTH. AVOID AMMONIA-BASED CLEANERS
FULL RANGE OPTICAL SWITCH

LOOSEN SET SCREW WITH PROVIDED HEX KEY
TO ALLOW REMOVAL OF ARM FROM BASE
6
5
7
7
8