Instructions for Making a Ribbon Stitch Pouch
Design
See the expansion
plan view on page 4
Arrange the square pieces, five-sided pieces,
and double-square pieces on a design sheet
according to the plan view design 1 on page 4.
Design a bag Connect with fixings
Insert the 4-pin fixings
in all the parts shown
in the expansion plan view.
Use shiny 4-pin fixings
with gems wherever
you like!
Use these two!
4-pin
fixing
Shiny 4-pin
fixings
with gem
Like this!
Connect with 3-pin fixings
Connect the double-square piece with the square pieces with the 3-pin fixings
. Insert the
short pin into the red hole and insert the two long pins into the other holes. Connect the
same pieces on the other side of the bag.
Fold
Fold downwards along the red line shown
on the plan view.
*If it does not stay down and returns to the
original shape, fold and hold down for a little
while.
Make a bag shape
Fold the pieces on the side gussets along
the blue line shown on the plan view on
page 4. Then, connect them by inserting the
4-pin fixings
into the holes with the same
numbers.
Attach the ribbon ! Be careful with eyes when using a plastic needle
Put the ribbon through the hole of a
needle and tie up softly.
Insert the needle from the back of the
piece with holes.
Put the needle through in numerical
order on a design sheet.
Fold and knit obliquely. Knit up to the point where it started. Make a knot tightly in the ribbon at the
backside after put the ribbon through
the holes. Cut off if any excess ribbon.
Fix edges of the Pouch
Connect the bag
inner and the bag
Insert the 2-pin fixings
into the top of the five-sided pieces.
Put the bag inner into the bag.
Put the pins for the 2-pin fixings
through the holes of
the bag inner, attach the 2-pin receptacles
, and press
them until they click.
Use this!
2-pin
receptacle
2-pin
receptacle
Bag
inner
Pieces
2-pin fixings
Attach the shoulder chain
(In case of making a shoulder bag)
Metal fixings
Get the shoulder chain.
Put the ribbon through the holes of the chain and make a knot tightly
in the ribbon at the end of the chain.
Attach the chain to the part as shown in the plan view.
Advise
Make a knot tightly in the ribbon
on a metal fixings.
Cut off any excess ribbon.
Caution !
Please handle the
needle with care
Instructions for
attaching decorations
Just put the clip into
the gap between the
pieces and bag inner
wherever you like!
With charms
& decorations
Done!
Make it like a hand bag
by grind a chain double
Design it
like this!
Expansion Plan View of Simple Pouch
Expansion Plan View of Simple Pouch
Design
Adult-like white pouch.
Shiny 4-pin fixings
with pearl
Attach it
wherever
you like.
Design Expansion Plan View of Bag with clear pocket
Put anything you like in a clear pocket and appeal to others
Instruction for using clear pocket
Fig-1 Fig-2
Decorate by putting anything you like in a clear pocket!
(Please do not put anything thick)
After putting decorations, connect by fixings into the holes with
the next pieces according to
Let's design a bag by rearranging the pieces in the expansion plan view!
Use this!
3-pin fixings
Instruction for
making the bag
Video Release!
