PAFtec CleanSpace PAF-1017 User manual

PAFtec Australia Pty Ltd
T: [phone]
GF 16-18 Carlotta St
[email protected]
ABN 24 146 453 554
F: [phone]
Artarmon NSW 2064 Australia
[email protected]
Spectacle Frame Kit PAF-1017
Instructions for fitting and use
FITTING SPECTACLE FRAME TO FULL FACE MASK
ENGLISH
Important! Before use,
the User must read and
understand these
instructions. Keep these
instructions for
reference.
Slide Block
Mounting Foot
and Rail
Spectacle
Frame
Note: Frames are supplied
with no lenses. Lenses
must be prescribed and
installed by an Optician or
Optometrist.
The CleanSpace Spectacle
Frame Kit (PAF-1017) allows
use of CleanSpace Full Face
Mask (PAF-1014) with
corrective prescription
lenses. Installation is easy
and requires no tools.
Warning: Do NOT USE CleanSpace Full Face Mask (PAF-1014) with regular eyeglasses, as these will cause the seal to be
broken and compromise fit and protection.
STEP 1. Remove Inner Mask Assembly from CleanSpace Full Face Mask
(PAF-1014) by squeezing the two tabs towards each other and pull the
inner mask backwards out of the mask
S005-7222 Rev 1, 4 August 2015 Released on Change Note ECN0609

STEP 2.Install Mounting Foot/Rail into the Inner Mask Assembly aligning the ‘dovetail’ with slot, then press
down. See images below.
STEP 3. Install Spectacle Frame into Slide Block by inserting pins into the holes. Then re-position Slide Block
Up/Down and Spectacle Frame In/Out for optimal fit, position and vision of the user.
STEP 4. Refit the inner mask complete with Spectacle Frame
Kit assembled. Insert the bottom of the inner mask first,
engaging the two ribs that protrude from the bottom of the
inner mask into the matching slots in the main frame. Once the
ribs are engaged, push the top of the inner mask forward until
it snaps into place.
Note: The Slide Block can
be reversed to allow
additional In/Out and/or
Up/Down adjustment.
Before attempting to use with CleanSpace respirator in
contaminated environment, user must Don the CleanSpace
Full Face Mask with installed CleanSpace Spectacle Frame Kit
(PAF-1017) and complete any fine adjustments to Spectacle
Frame position and verify that vision is appropriately
corrected.