Pain Management Technologies Micro EQC User manual

- 1 -
OPERATION OF THE Micro EQC
Micro EQC is easy to operate using the keys shown in the
following diagram.
WHAT DOES EACH KEY DO
This key switches the unit on or off. Press and
hold for more than 3 seconds the unit is on, the LCD
display located at the front of the unit will light up, there
will be no feeling from either lead at this point as the
intensity always starts at zero. Press and hold this key for
more than 3 seconds, the unit will switch off.
Press this key you can go through and select the
parameters one by one.
Press these keys to increase or decrease the
value of the parameter, which has been selected
by MENU key.
Press these keys to adjust the intensity of channel
1 and channel 2. Left side is for channel 1; right

- 2 -
side is for channel 2.
Pause key: Press this key to make the unit pause;
to continue it, press and hold down this key again.
Press this key for 3 seconds can LOCK or
UNLOCK the parameters in toggle. When the unit is
locked, only intensity and treatment timer can be adjusted.
The symbol displayed on the LCD screen indicates
that the unit is locked.
Press this key can be used for modifying the
waveform. The symble will display on the LCD
accordingly.
Press this key can switch between uAand mA.
Press this key to enable or disable the backlight of
the device. When the backlight is enabling, each time
when a key is pressed, the backlight is lighted and last 10
seconds.

- 3 -
SPECIFICATION
Model: Micro EQC
Microcurrent:
Frequency 15KHz fixed / 0.5-120Hz adjustable
Pulse width 25uS fixed
Wave form Upside Mono-Phasic,
DownsideMono-Phasic,
Alternated Mono-Phasic
OTHER FEATURES
1. When the unit is turned on, if any of the keys are not
pressed within 5 minutes, it will automatically shut off.
2. When the unit is turned off and turned on again or the
battery is removed, all parameters are remain
unchanged except the intensity and treatment timer.
3. When the treatment is completed, the unit will shut
down automatically after 10 beep sounds.

- 4 -
Waveform Information
There are 3 types of waveforms:
(1).Upside Mono-PhasicWaveform
Amplitude
Time
(2).Downside Mono-Phasic Waveform
Amplitude
Time
(3).Alternated Mono-Phasic Waveform
Amplitude
Time