Panasonic KX-T30865 User manual

Manual Type 1.0.0.2E-RF
EURO INTERCOM UNIT
Panasonic K T-30865
For Models
For all Holovision models to be used
with KX-T30865 door phone
Specifications
Communication
For use with all Panasonic KS s with door phone
card. This manual provides details of the
mounting of KX-T30865 to models 106, 202.
Installer furnishes his own KX-T30865 door
phone and attaches to Holovision plate with
bracket which is supplied.
Access Control
None.
INSTALLATION
INSTRUCTIONS
501 E. Goetz Ave.
Santa Ana, Ca 92707
www.eholovision.com
Ph. 714-434-6904
Fax [phone]
HOLOVISION
KX-T30865 DOC
Front View
Door bell
button
T
RK -T30865
Microphone
Speaker
KS
Strike 1
Door 1

Page 2 TYPE 1.0.0.2E-RF
Installation Instructions for Panasonic K T-30865
1 Disassemble KX-T30865
2 Cut input wires free from plastic back plate
3 Connect doorbell button, circuit board, and wires to KS as shown on page 1
4 Lay Holovision door intercom on a flat surface (be careful not to scratch it.)
5 Remove the speaker attachment bracket from the door station so that it looks as shown below in Figure A
6 Place the Panasonic speaker in the middle of the door unit as shown below in Figure B
Set Master Code
STEP ACTION
Panasonic circuit
board
Microphone
Figure A
Figure B

TYPE 1.0.0.2E-RF Page 3
Installation Instructions for Panasonic K T-30865
7 Pass the Panasonic circuit board and microphone through the hole in the speaker attachment bracket as shown below in Figure C
8 Place the speaker bracket over the speaker and attach it to the lower bracket using the 4 screws provided.
See illustration below in Figure D
9 Attach the Panasonic circuit board to the speaker bracket using the screw provided
10 Secure the Panasonic microphone underneath the speaker bracket, making sure that the mic aligns with the hole shown above
Set Master Code
STEP ACTION
Microphone
hole for Step10
Panasonic circuit
board
Insert microphone
from this side
Figure C
Figure D

501 E. Goetz Ave.
Santa Ana, Ca 92707
Ph. 714-434-6904
Fax [phone]
www.eholovision.com