Panavise Indash 75114-296 User manual

PART#: 75114-296
MFG: PONTIAC
MODELS & YEARS:
GRAND AM 96-2000
GRAND PRIX 97-2001
MOUNTING LOCATION:
Right side of radio
TOOLS REQUIRED:
7mm nut driver
7mm open-end wrench
Medium & short/medium
Phillips screwdrivers
HARDWARE INCLUDED:
None
I-75114-296
Page 1 of 2
* * ADVISEMENT * *
Read instructions completely prior to
starting installation. All InDash Mounts
aredesignedsothatafterinstallation,phone
is facing normal driver position for left-
hand drive vehicles. This mount is not
designed to be used in foreign countries
withright-handdrivevehicles.Useextreme
care when working around the plastic
components on the dash. Excess force,
can cause breakage of the plastic
components.
CELL PHONE & MEDIA MOUNT
INSTALLATION INSTRUCTIONS
INSTRUCTIONS FOR GRAND AM/GRAND PRIX 96-98 ONLY:
STEP #1 Remove two Phillips screws from the rear inside of the utility compartment located above the shifter
console.
STEP #2 RemovetwoPhillipsscrewsfromthemoldingabovetheinstrumentcluster. Releasethemainmolding
bezelwhichsurroundstheradioandclimatecontrol. Pullatthetoprightcorneroftheradio;pullback
far enough to remove the 7mm Hex/Torx head screw from the right side of the radio mounting.
STEP #3 Place the InDash Mount over the bezel from inside the radio opening and position the mounting hole
over the open hole of the radio mounting. Place the 7mm Hex/Torx screw through the InDash Mount
and into the radio mounting hole and tighten with the 7mm open end wrench. Snap bezel back into
place and reinstall screws.
STEP #4 InstallphoneholdertoInDash Mount with the supplied Hexheadscrews. IfusingaPortaGripModel
#701, adjust it to the size of the phone prior to mounting.
INSTALLATION IS NOW COMPLETE. ENJOY YOUR NEW PANAVISE INDASH MOUNT.
(SEE OTHER SIDE FOR THE GRAND AM/GRAND PRIX 99 INSTRUCTIONS)
Grand AM 1999 Mount Grand Prix 2001 Mount

I-75114-296 / Page 2 of 2
08-29-00
T ere may be recent updates to t is Instruction S eet, please visit our website or contact PanaVise Products, Inc. for t e latest revision as well as for t e most
complete up-to-date PanaVise InDash Applications List: 7540 Colbert Dr., Reno, NV, P one: 800.759.7535, 775.850.2900, Fax: [phone], www.panavise.com
INSTRUCTIONS FOR GRAND AM 99-2000 ONLY:
STEP #1 Apply emergency brake, turn ignition on, DO NOT START vehicle and shift into first gear. With the
hook tool remove the molding that surrounds the radio and climate control by pulling from the top
round corners and working your way toward the bottom to release all clips. Once clips have been
released push molding to the left. DO NOT DISCONNECT WIRES.
STEP #2 Removeonescrewlocatedontherightsideoftheradio. AttachphoneholdertoIndashMount.Ifusing
a PortaGrip phone holder; adjust to size of phone prior to mounting. Place the Indash Mount over the
screwhole and guide pin,the second bendof the Indash willrest on the faceof the radio.Reinstall the
one screw and tighten with a 7mm open end wrench.
STEP #3 ReinstallthemoldingbackintoplacebyguidingtheIndashthroughtheradioopeningofthemolding.
Align all clips and push to secure in place.
STEP #4 AttachphoneholdertoIndashMount. Ifusinga PortaGripphoneholder,adjusttosizeofphoneprior
to mounting.
INSTALLATION IS NOW COMPLETE. ENJOY YOUR NEW PANAVISE INDASH MOUNT.
INSTRUCTIONS FOR GRAND PRIX 99-2001 ONLY:
STEP #1 With the hook tool pull the bezel that surrounds the radio starting from the top and to the right of the
center air vents. Release the right side of the bezel; once released pull the bezel from the right side
of the radio and remove the screw from the right side of the radio.
STEP #2 AttachphoneholdertoIndashMount. Ifusinga PortaGripphoneholder,adjusttosizeofphoneprior
to mounting. Place the Indash Mount through the radio opening of the bezel and align holes. While
holding the bezel, reinstall the screw on the right side of the radio using the open end wrench.
STEP #3 Push the bezel back into place starting from the bottom side
INSTALLATION IS NOW COMPLETE. ENJOY YOUR NEW PANAVISE INDASH MOUNT.
Installation location Grand Am Installation Grand Prix