PANCONNECT UNI User manual

UNI
Installation
manual
A
A
B
size of the
panel
A×B
UNI 4
268 mm ×127 mm
size of the
panel
A×B
UNI 6
377 mm ×127 mm
Technical
parameters
A
B
A
1 |
Based on the chosen size,
mark size of the hole in
order to place the panel
2|
Drill two holes
in the opposite corners
inside of the frame
Cut the corners
sharply
3|
Take a jig saw and cut
the hole

4|
Insert the panel into
the hole
5|
Insert a clip into the groove
in the lower part of
the panel
For the desk height 10- 25 mm use upper groove,
for the desk height 24 - 42 mm use lower groove.
6|
Use hex key no.3 to tighten
the clip
7|A
If you've chosen pullout for your panel,
place it on the lower part of the panel
next to a cartridge and move
it to the grooves
(in the arrow's direction)
8|A
Tighten the pullout's screws
into the panel

7|B
If you've chosen CMS for your panel, screw in the cover plate
to CMS using countersunk-head bolts
8|B
Place CMS to the lower part of the panel
and move it to the grooves
(in the arrow's direction)
9|B
Tighten the screws into the panel
10|B
Link CMS and cartridge with connection cable (if you have
more CMS in your panel, connect them as well)
UNI
More details: