Pando Curve User manual

660066400109
INSTALLATION GUIDE
CURVE

1





CURVE HOOD
ATTENTION!
Please read the User Manual before installing and using the range hood.
The hood must be centered over the cooking area. If this requirement is
not fulfilled, correct aspiration is NOT GUARANTEED.
Before begin the installation, please verify that the diameter of the flue,
the engine and the SEC tube are the indicated in their respectives characteristics
table.
Do not use the SEC tube as a cover of another tube smaller.
Do not connect the hood to the main supply until the installation. (Step 8).

2
1– Unpack the range hood CURVE. Verify the condition of the range hood.
2– Drill the holes in the wall how is indicated in the fig.1, mantaining the axis in the middle
of the cooking area. Put the decorative flue's mounting bracket furring to the ceiling,
and in the middle of the axis, and drill the holes necessaries to fix it.
Advertise: This measures are the recommended for the installation, therefore for the
CURVE C version as for the CURVE L version.
Fig. 1
AXIS CABINET
CABINET

3
3- Insert the plugs, and put the hood support by screws.
4- Hang the hood, aligning the wall support to the hook in the rear of the hood.

4
5- Screw the hood by the holes as in the figure.
6- Intube the engine and the flue with the SEC tube, by following the tips of the User,
Installation Manual. Fix the connections hermetically with the flanges.