Panduit SmartZone PViQ Use and care manual

1
Technical Reference 78-SZ
Parts Required
Description Part Number Manufacturer
POE Power splitter PD-AS-701/12 PowerDsine
2.5mm jack to 2.1mm plug adapter DCA-1 Allied Electronics
2.5mm jack to 2.5mm plug –plug cord 839-1009-ND Digi-key
Hook and loop cable tie mount ABMT-S6-C20 Panduit
Hook and loop strip HLS1.5S-X0 Panduit
Using a Power Splitter to Power PVIQ Panels
Applies to:
SmartZone PVIQ Panels
Objective:
The purpose of this Technical Reference is to demonstrate how to use a
PoE splitter (PowerDsine 701 high power splitter) and a PanView
DPoE8S2XG DPoE panel as a power resource for the PanView iQ™
(PViQ™) Panel Manager.
Pre-Requisites:
Currently the PViQ Panel Manager only accepts power through a DC
jack connector using the brick power converter AC 120V – DC 12V, but a
PoE splitter and a DPOE Panel could also be used to power the Panel
Manager.
Published: 7/25/18

www.panduit.com 2
Performing the Procedure
General configuration overview

www.panduit.com 3
Mounting the PoE splitter using the hook and loop strip
Attach the hook tie mount to the PoE splitter as depicted in figure a and loop the strip through the
buckle as show in figure b
Figure a) Hook tie mount attached to power splitter
Figure b) Hook and loop strip attached to power splitter

www.panduit.com 4
Connect the cable adaptor extension to PViQ panel
Use the jack plug connector to properly accommodate the power input of the PM to the power output
cable of the power splitter as depicted in figure c
Figure c) 2.5mm cable to 2.1mm conversion using the cable adaptor
Mounting the Power Splitter
Mount the POE power splitters using the hook tie loop behind the rack or in a convenient easy to
access location near the Panel Manager as depicted in Figures c and d

www.panduit.com 5
Figure d) PoE mounted behind the rack
Figure e) PoE splitter mounted near Panel Manager

www.panduit.com 6
Connectivity
Start by making the connection from the network to the DPoE panel (or any other PoE power injector)
and to the PoE power splitter ending at the Panel Manager as depicted in Figure e
Figure e) Network Connectivity